Acura RL (1996-2004 year). Manual — part 326
Engine Removal/Installation
Removal (cont'd)
44. Remove the heat shield.
Loosen these
bolts.
HEAT
SHIELD
6 x 1.0 mm
9.8 N-m (1.0 kgf-m, 7.2 Ibf-ft)
45. Remove the ATF cooler hoses. Plug the ATF cooler
hoses and lines.
6 x 1.0 mm
12 N-m (1.2 kgf-m
8.7 Ibf-ft)
LOCKNUT
16 N-m (1.6 kgf-m,
12 Ibf-ft)
SHIFT CABLE
HOLDER
SHIFT CABLE
COVER
CONTROL
LEVER
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
ATF COOLER
HOSES
46. Remove the shift cable cover mounting bolts, then
remove the shift control solenoid valve/linear sole-
noid harness connector from the shift cable cover.
47. Remove the shift cable cover from the transmission
housing.
48. Remove the shift cable with shift cable holder from
the shift cable holder base.
49. Remove the control lever from the control shaft.
50. Lower the hoist.
51. Remove the upper and lower radiator hoses.
UPPER RADIATOR
HOSE
LOWER RADIATOR
HOSE
52. Remove the radiator assembly (see page
).
53. Remove the heater hoses.
HEATER
HOSES
Main Menu
Table of Contents
54. Attach the chain hoist to the engine.
FUEL PRESSURE REGULATOR
29 N-m (3.0 kgf-m, 22 Ibf-ft)
NOTE: Loosen the locknut on the
fuel pressure regulator, then turn
the fuel pressure regulator 180°.
Main Menu
Table of Contents
Engine Removal/Installation
Removal (cont'd)
55. Raise the hoist.
56. Remove the shift cable guide.
CAUTION: Take care not to bend the shift cable
).
57. Remove the transmission beam.
TRANSMISSION
BEAM
58. Remove the transmission mount and transmission
mount bracket.
TRANSMISSION,
MOUNT
TRANSMISSION
MOUNT BRACKET
59. Lower the hoist.
60. Separate the left front mount bracket from the left
front mount.
LEFT FRONT
MOUNT
61. Separate the right front mount bracket from the
right front mount.
RIGHT FRONT
MOUNT
Main Menu
Table of Contents
62. Separate the right engine mount bracket from the
right engine mount, then remove the vacuum hose.
RIGHT ENGINE
MOUNT BRACKET
VACUUM
HOSE
RIGHT ENGINE
MOUNT
63. Separate the left engine mount bracket from the left
engine mount, then remove the vacuum hose.
LEFT ENGINE
MOUNT BRACKET
LEFT ENGINE
MOUNT
VACUUM
HOSE
64. Raise the chain hoist to remove all slack from the
chain.
65. Check that the engine/transmission is completely
free of vacuum hoses, fuel and coolant hoses and
electrical wiring.
66. Slowly raise the engine approximately 150 mm (6 in).
Check once again that all hoses and wires are discon-
nected from the engine/transmission.
67. Raise the engine all the way, and remove it from the
vehicle.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст