Acura RL (1996-2004 year). Manual — part 570
9. Remove the rail holder A.
6 x 1.0 mm
9 N-m (0.9 kgf-m,
7 Ibf-ft
RAIL HOLDER A
GUIDE
RAIL
DRAIN CHANNEL ROD STOP
Rotate as shown to remove it from the guide rail.
10. Remove the drain channel rod slider by moving the
cable slider forward using the moonroof wrench.
11. Detach the drain channel rod stop from the cutout
of the guide rail as shown.
12. Slide the sunshade forward, then remove it.
SUNSHADE
13. Installation is the reverse of the removal procedure.
NOTE: Check the glass height (see page
).
14. Check for water leaks.
NOTE: Do not use high-pressure water.
DRAIN CHANNEL
ROD
DRAIN CHANNEL
ROD SLIDER
GLASS BRACKET
Main Menu
Table of Contents
Moonroof
Motor, Drain Tube and Frame Removal
CAUTION:
• Put on gloves to protect your hands.
• Be careful not to damage the seats, dashboard, and other interior trim.
1. Remove the headliner (see page
).
2. Disconnect the connectors, detach the harness clip, and remove the ground wire.
NOTE: When removing the motor, disconnect the motor connector, detach the connector from the frame, remove the
bolts and nuts, then remove the motor.
).
4. Disconnect the drain tubes.
5. Remove the frame mounting bolts.
NOTE:
An assistant is helpful when removing the bolts.
Remove the front bolts last.
6. Detach the rear hooks by moving the frame forward, then remove the frame.
Bolt locations
Nut locations, 3
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
6 x 1.0 mm
9.8 N-m (1.0 kgf-m,
7.2 Ibf-ft)
REAR
HOOK
GROUND
WIRE
MOTOR
CONNECTOR
HARNESS
CLIP Remove
last.
Remove last.
HOLE
(Body side)
MOTOR
TUBE
CLIP
CONNECTORS
FRAME
SEAL
DRAIN
TUBE
FRAME
Main Menu
Table of Contents
7. Pull the drain tubes out the front and rear pillars.
NOTE: Before pulling out the drain tube, tie a string
to the end of it so it can be reinstalled.
8. Installation is the reverse of the removal procedure.
NOTE:
• Before installing the frame, clear the drain tubes
and drain valves by using compressed air.
• Check the frame seal.
• Clean the surface of the frame.
• When installing the frame, first attach the rear
hooks into the body holes.
• When connecting the drain tube, slide it over the
frame nozzle at least 10 mm (0.39 in.).
• Install the tube clip as shown.
9. Check for water leaks.
NOTE: Do not use high-pressure water.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст