Acura RL (1996-2004 year). Manual — part 563
Door Panel Removal
NOTE: Take care not to scratch the door panel and other
parts.
1. Remove the trim plate, then remove the screws.
NOTE: Do not remove the inner handle from the
door panel.
Pry here.
TRIM
PLATE
2. Remove the screw and stop. Release the clips that
hold the door panel, then remove the door panel by
pulling it upward. Disconnect the connectors and
inner handle cable.
NOTE: Remove the door panel with as little bend-
ing as possible to avoid creasing or breaking it.
95 mm (3.74 in.)
TRIM PAD
REMOVER
(Commercially
available)
Snap-on
#A177, or
equivalent
12 mm
(0.47 in.)
1 mm
(0.04 in.)
45°
45 mm
(1.77 in.)
Clip locations
DOOR
PANEL
CLIP
POWER WINDOW
SWITCH
CONNECTOR
INNER
HANDLE
CABLE
STOP
DOOR
PANEL
ASHTRAY
LIGHT
COURTESY
LIGHT
CONNECTOR
3. Installation is the reverse of the removal procedure.
1
Screw locations, 2
INNER HANDLE
TRIM PAD
REMOVER
Screw location, 1
Main Menu
Table of Contents
Doors
Outer Handle/Latch Removal
1. Remove:
Sash trim (see page
Glass
Rear channel (see page
2. Remove the rod protector.
Screw locations, 2
HOOK
3. Remove the outer handle cover, then remove the
outer handle holder.
NOTE:
Take care not to drop the bolt inside the door.
Remove in numbered sequence.
Bolt locations
COLLAR
4 x 0.8 mm
3 N-m (0.3 kgf-m,
2 Ibf-ft)
OUTER
HANDLE
COVER
OUTER
HANDLE
BASE
OUTER HANDLE
HOLDER
HOLE SEAL
4. Remove the outer handle as shown.
OUTER HANDLE
BASE
LEVER
SEAT B
5. Remove the seat A, then loosen the bolt.
OUTER
HANDLE
BASE
SEAT A
5 x 0.8 mm
5 N-m (0.5 kgf-m,
4 Ibf-ft)
Loosen.
ROD
PROTECTOR
HOOK
5 x 0.8 mm
5 N-m (0.5 kgf-m,
4 Ibf-ft)
OUTER
HANDLE
SEAT A
SEAT B
OUTER
HANDLE
Main Menu
Table of Contents
6. Slide the outer handle base, and remove it from the
door. Disconnect the connector, detach the clips,
and remove the lock crank, then remove the latch
with the outer handle base through the hole in the
door. Pry the outer handle rod out from the outer
handle base using diagonal cutters.
NOTE:
• To ease reassembly, note location of the outer
handle rod on the joint before disconnecting it.
• Take care not to bend the rods.
7. Installation is the reverse of the removal procedure.
NOTE: Make sure the door locks and opens properly.
Main Menu
Table of Contents
Glass/Quarter Glass/Regulator
Removal
1. Remove:
2. Carefully move the glass until you can see the bolts,
then remove them. Carefully pull the glass out through
the window slot.
NOTE: Take care not to drop the glass inside the door.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст