Acura RL (1996-2004 year). Manual — part 455
Transmission Range Switch (A/T Gear Position
Switch)
Removal
1. Shift the detent lever to the position.
TRANSMISSION
RANGE SWITCH
LOCKNUT
LOCK WASHER
Replace.
DETENT
LEVER
CONTROL
SHAFT
2. Pry the locktabs on the lock washer, then remove
the locknut and lock washer.
3. Remove the bolts securing the transmission range
switch, then remove the transmission range switch.
Main Menu
Table of Contents
Transmission Range Switch (A/T Gear Position
Switch)
Installation
1. Set the transmission range switch to the position
as shown.
NOTE: The transmission range switch clicks in the
position.
POSITION MARK
TRANSMISSION RANGE
SWITCH
CONTROL SHAFT
HOLE
2. Shift the detent lever to the position.
CONTROL
SHAFT
DETENT LEVER
Main Menu
Table of Contents
3. Install the transmission range switch on the control
shaft, then install the bolts loosely.
TRANSMISSION
RANGE SWITCH
CONTROL
SHAFT
6 x 1.0 mm
Tighten loosely.
4. Install a new lock washer on the transmission range
switch by aligning its projected tip with the posi-
tion mark on the transmission range switch as
shown.
POSITION
MARK
TRANSMISSION RANGE
SWITCH
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
DETENT
LEVER
LOCKNUT
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
CONTROL
SHAFT
5. Tighten the locknut while holding the detent lever in
the position, then bend the lock tabs against the
locknut.
6. Tighten the 6 mm bolts to the specified torque.
LOCK WASHER
Replace.
Main Menu
Table of Contents
Transmission
Reassembly
NOTE:
• Coat all parts with ATF.
• Replace the following parts:
- O-rings
- Lock washers
- Gaskets
- Mainshaft and countershaft locknuts and conical disc springs
- Sealing washers
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст