Acura RL (1996-2004 year). Manual — part 664
Power Mirror Test
).
POWER MIRROR
10P [8P]
CONNECTOR
2. Disconnect the 10P [8P] connector from the power
mirror actuator.
3. Check actuator operation by connecting power and
ground according to the table.
[ ]: Without memory
Defogger Test:
4. Check for continuity between the No. 3 [No. 2] and
No. 4 [No. 3] terminals of the 10P [8P] connector.
There should be continuity.
5. If the mirror fails to work properly, replace the mir-
ror actuator or mirror sub assembly (see page
).
[ ]: Without memory ('98 model)
With memory
Wire side of
female terminals
Without memory
Wire side of
female terminals
Main Menu
Table of Contents
4. Disconnect the heated mirror 2P connector (with
heated mirror).
5. Disconnect the power mirror position sensor 5P
connector (with DPMS).
Power Mirrors
Power Mirror Actuator Replacement
1. With the mirror still on the vehicle, press in on the
upper half of the mirror to create a gap at the lower
edge between the mirror housing and the mirror.
Look up through the gap to locate the two slots in
the bottom of the actuator.
ADHESIVE TAPE
MIRROR
HOUSING
LOCATOR
CLIPS
SHOP TOWEL
MIRROR
HOLDER
2. Insert a flat tip screwdriver into the two slots. The
mirror is fastened to the actuator with doublebacked
adhesive tape. Twist the screwdriver gently to
release the mirror. (Protect the paint with a towel
inserted between the screwdriver and the mirror
housing.)
3. Release the mirror holder hooks from the actuator,
and remove the mirror.
MIRROR HOLDER
HOOK
2P CONNECTOR
5P
CONNECTOR
ACTUATOR
13. Run the actuator motor through its full range in all
four directions. The mirror should move smoothly.
6. Without removing the center screw, remove the
Phillips head screws that attach the actuator to the
mirror housing.
7. Disconnect the four actuator wires; gently pull the
base of the rubber seal around each actuator wire.
8. Connect the actuator wires and power mirror posi-
tion sensor 5P connector to the new actuator exactly
as they were. Press each seal firmly against the back
of the new actuator.
9. Attach the actuator to the housing with the Phillips
head screws removed in step 6.
10. Connect the heated mirror 2P connector.
11. Refasten the mirror holder hooks.
12. Lock the lower locator clips and restick the double-
backed adhesive tape by squeezing the actuator and
the mirror together at the lower edge with your fin-
gers.
Main Menu
Table of Contents
Homelink
®
Remote Control System
Test
Turn on the spotlight.
• If the driver's vanity mirror light comes on, the
Homelink's power and ground circuits are OK. If the
Homelink will not open the customer's garage door,
check that the Homelink is programmed properly (see
the owner's manual) or call Homelink at 800 - 355 -
3515. On the internet, go to www.homelink.jcl.com.
• If the driver's vanity mirror light does not come on,
check for these problems:
A blown No. 57 (20 A) fuse in the under-hood
fuse/relay box.
An open in the WHT/BLU wire between the under-
hood fuse/relay box and driver's vanity mirror
light.
An open in the BLK wire between the driver's vani-
ty mirror light and G401, G402.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст