Acura RL (1996-2004 year). Manual — part 625
3. Remove the seven (or eight) mounting screws, then
remove the audio unit.
4. Install in the reverse order of removal.
5. After installing the audio unit, enter the anti-theft
code for the radio, then enter the customer's radio
station presets.
Without navigation system:
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
radio's preset buttons.
2. Remove the automatic climate control panel and
).
SCREW
AUDIO
UNIT
BRACKET
BOLT
Main Menu
Table of Contents
3. Remove the CD changer bracket mounting bolts,
then remove the CD changer and bracket.
4. Remove the DIN cord from the CD changer.
5. Remove the eight mounting screws, then remove
the CD changer from the bracket.
Stereo Sound System
CD Changer Removal
1. Open the trunk lid.
2. Remove the CD changer cover.
Stereo Amplifier Removal
).
2. Loosen the three amplifier mounting bolts.
COVER
CD CHANGER
CD CHANGER
BRACKET
STEREO
AMPLIFIER
MOUNTING
BOLTS
CONNECTORS
3. Slide the amplifier out of its three mounting slots,
disconnect the 12P and 18P connectors, then
remove the amplifier.
Main Menu
Table of Contents
Speaker Replacement
Front Door Speaker:
1. Remove the front door panel (see
).
2. Remove the four screws, then disconnect the 2P
connector from the speaker.
1. Remove the front door panel (see
).
2. Remove the speaker cover.
3. Remove the two screws and tweeter.
TWEETER
SPEAKER
COVER
2P CONNECTOR
SPEAKER
SCREW
Rear Speaker:
1. Remove the rear seat back (see
).
).
3. Remove the four screws, then disconnect the 2P
connector from the speaker.
4. Remove the speaker from the speaker adapter.
Rear Door Speaker:
1. Remove the rear door panel (see
).
2. Remove the four screws, then disconnect the 2P
connector from the speaker.
2P CONNECTOR
SCREW
SPEAKER
Main Menu
Table of Contents
Stereo Sound System
Radio Remote Switch Test
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS (
) before performing repairs or
service.
1. Remove the switch cover from the radio remote
switch.
RADIO REMOTE SWITCH
SWITCH COVER
2P CONNECTOR
2. Remove the radio remote switch from the steering
wheel by removing the two screws, and disconnect
the 2P connector.
3. Remove the remote switch from the steering wheel
(see
).
4. Measure resistance between the No. 1 and No. 2
terminals in each switch position according to the
table.
Position
Resistance
Approx. 100
Approx. 350
Approx. 770
Approx. 3.6
OFF
AUDIO/CH
(SEEK)
(VOL. UP)
(VOL. DOWN)
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст