Acura RL (1996-2004 year). Manual — part 640
Driving Position Memory
Switch Test
1. Remove the driver's door panel (see
).
2. Disconnect the 10P connector from the memory
switch.
MEMO BUTTON
INDICATORS
(LED)
Terminal side of
male terminals
POSITION
BUTTONS
3. Check for continuity between the terminals in each
switch position according to the table.
3. Check for continuity between the terminals in each
switch position according to the table.
Steering Column Switch Test
1. Remove the steering column covers (see
).
2. Disconnect the 7P connector from the switch, then
remove the switch from the steering column lower
cover.
STEERING COLUMN SWITCH
STEERING COLUMN
LOWER COVER
Main Menu
Table of Contents
Driving Position Memory System (DPMS)
Tilt/Extend-retract Motor Test
1. Remove the steering column covers (see
).
2. Disconnect the connector from each motor.
EXTEND-
RETRACT
MOTOR
EXTEND-RETRACT MOTOR TILT MOTOR
2P CONNECTOR 3P CONNECTOR
3. Test the motors according to the table:
Tilt Motor:
Extend-retract Motor:
CAUTION: When a motor stops running, disconnect
battery power immediately.
Tilt/Extend-retract Position Sensor
Test
1. Remove the steering column covers (see
).
2. Disconnect the 4P connector from the sensor.
EXTEND-
RETRACT
POSITION
SENSOR
4P CONNECTOR
Terminal side of
male terminals
3. Measure resistance between the terminals in each
position according to the table.
Position
Terminal
Resistance
Terminal side of
male terminals
TILT
MOTOR
TILT
POSITION
SENSOR
Main Menu
Table of Contents
2. Disconnect the 10P connector from the switch, then
remove the switch from the cover by removing its
two mounting screws.
Driver's Power Seat Switch Test
1. Remove the adjustment switch cover, and pull off
the adjustment switch knob (see
).
DRIVER'S POWER SEAT
ADJUSTMENT SWITCH
3. Check for continuity between the terminals in each
switch position according to the table.
Main Menu
Table of Contents
Driving Position Memory System (DPMS)
Driver's Power Seat Motor Test
CAUTION: Be careful not to damage the seat, interior
trim or body.
1. Remove the driver's seat (see
).
2. Disconnect the connector from each power seat
motor.
Terminal side of male terminals
RECLINE MOTOR
REAR UP-DOWN
MOTOR
DRIVER'S SEAT
FRONT UP-DOWN
MOTOR
Terminal side of male terminals
SLIDE MOTOR
3. Test the motors according to the table:
CAUTION: When a motor stops running, disconnect
battery power immediately.
4. If the motor does not run or fails to run smoothly,
).
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст