Acura RL (1996-2004 year). Manual — part 239
Precharge Brake Line Bleeding
1. Connect the SCS service connector to the service check connector (2P) located under the glove box.
2. Press the parking brake pedal.
3. Press the VSA off switch, and hold it.
4. Turn the ignition switch ON (II).
5. Release the VSA off switch after the VSA activation indicator goes off twice.
6. Press the VSA off switch after the VSA activation indicator comes on.
7. Release the VSA off switch after the VSA activation indicator goes off.
8. Press the VSA off switch after the VSA activation indicator starts blinking.
9. Release the VSA off switch after the precharge pump motor stops running.
10. Turn the ignition switch OFF, then repeat steps 2 through 10 four times.
Main Menu
Table of Contents
Mirrors
Rearview Mirror Removal - with OnStar System
1. Carefully remove the rearview mirror base lower
cover with a flat-tip screwdriver.
CAUTION: When prying with a flat-tip screwdriver,
wrap it with protective tape to prevent damage.
REARVIEW MIRROR
HARNESS UPPER
COVER
HOOKS
REARVIEW MIRROR
BASE LOWER COVER
HOOK
LOWER
COVER
2. Carefully remove the rearview mirror harness upper
cover with a flat-tip screwdriver.
CAUTION: When prying with a flat-tip screwdriver,
wrap it with protective tape to prevent damage.
HARNESS COVER
CLIP
HOOK
HOOK
UPPER
COVER
REARVIEW MIRROR
HARNESS UPPER
COVER
REARVIEW MIRROR
HARNESS COVER
CLIP
3. Disconnect the connector, and loosen the screw
with a Torx T20 bit, then slide the rearview mirror
rearward and off the lug.
LUG
CONNECTOR
SCREW
5
x
0.8 mm
2.8 N-m (0.29 kgf-m,
2.1 Ibf-ft)
Loosen.
REARVIEW MIRROR
4. Install the mirror in the reverse order of removal.
NOTE:
• Before installing the mirror, remove the Torx
screw, and apply liquid thread lock to it.
• Make sure the connector is plugged in properly.
HOOKS
REARVIEW
MIRROR
BASE
Main Menu
Table of Contents
Relay and Control Unit Locations
Engine Compartment
UNDER-HOOD RELAY,
BOX B
IGNITION CONTROL
MODULE (ICM)
CIGARETTE LIGHTER RELAY
- FRONT SEAT HEATER RELAY
('96 - 97 models)
- DRIVER'S POWER WINDOW MOTOR RELAY A
('98 - 01 models)
• HORN RELAY
('96 - 97 models)
• POWER WINDOW MASTER SWITCH
RELAY ('98 - 02 models)
SPARK PLUG VOLTAGE
DETECTION MODULE
• HEADLIGHT RELAY
('96 - 98 models)
• HEADLIGHT
LOW BEAM RELAY
('99 - 02 models)
• TAILLIGHT RELAY
('96 - 98 models)
• HEADLIGHT HIGH BEAM RELAY
('99 - 02 models)
DIMMER RELAY
UNDER-HOOD
FUSE/RELAY
BOX
DRIVER'S POWER WINDOW MOTOR RELAY B
('98 - 01 models)
• ABS PUMP MOTOR RELAY
('96 - 99 models)
• VSA FAIL-SAFE RELAY
('00 - 02 models)
Main Menu
Table of Contents
Power Door Locks
Component Location Index
'02 model:
NOTE: Refer to the '96 - 01 3.5RL Service Manual, P/N 61SZ305,
for the items not shown in this section.
UNLOCK BUTTON
LOCK BUTTON
TRUNK
BUTTON
PANIC BUTTON
DRIVER'S DOOR
LOCK SWITCH*
Test/Replacement, page
DRIVER'S DOOR LOCK ACTUATOR
Test, page
DRIVER'S DOOR
KEY CYLINDER SWITCH*
DRIVER'S DOOR LOCK*
KNOB SWITCH
Test, page
LEFT REAR DOOR LOCK ACTUATOR
Test, page
LEFT REAR DOOR LOCK
KNOB SWITCH*
TRUNK LID OPENER
SOLENOID
*: You can also test the switches by using the self-diagnosis function (mode 2). (See page
of the '96 - 01 3.5RL
Service Manual.)
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст