Acura TSX / Honda Accord CL. Manual — part 69

Fig. 5: Disconnecting The Cable Reel 13P Connector From The Dashboard Wire Harness

3. Using a jumper wire, connect the No. 1 terminal of the dashboard wire harness 13P connector to body

ground.

z

If the horns sound, go to step 4.

z

If the horns don't sound, check these items:

„

No. 13 (20A) fuse in the under-hood fuse/relay box.

„

Relay module in the under-hood fuse/relay box.

„

Horns (see HORN TEST/REPLACEMENT ).

„

An open in the wire.

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Horns - TSX

4. Reconnect the cable reel 13P connector (A) to the dashboard wire harness.

Fig. 6: Reconnecting The Cable Reel 13P Connector To The Dashboard Wire Harness

5. Remove the driver's airbag assembly (see AIR BAG RESTRAINT SYSTEMS ), and disconnect the

horn switch 1P positive terminal from the cable reel (B).

6. Using a jumper wire, connect the cable reel side 1P connector (C) to body ground.

z

If the horns sound, replace the driver's airbag assembly.

z

If the horns don't sound, replace the cable reel.

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Horns - TSX

2004 ACCESSORIES & EQUIPMENT

Ignition Switch - TSX

TEST

SRS components are located in this area. Review the SRS component locations and precautions and procedures
in the SRS section before performing repairs or servicing. See AIR BAG RESTRAINT SYSTEMS .

1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the

frequencies for the radio's preset buttons.

2. Disconnect the battery negative cable.

3. Remove the left front door sill trim and left kick panel (see INTERIOR TRIM ).

4. Disconnect the 6P connector from the driver's under-dash fuse/relay box.

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Ignition Switch - TSX

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Ignition Switch - TSX

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Ignition Switch - TSX