Acura TSX / Honda Accord CL. Manual — part 794
Fig. 75: Installing The Idler Gear, Then Installing The Ball Bearing On The Idler Gear
3. Install the conical spring washer (K) and locknut (L), then tighten the locknut to 29 N.m (3.0 kgf.m, 22
lbf.ft).
4. Turn the secondary shaft assembly upside down, and set the dial indicator (A) on the 1st gear (B).
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 76: Turn The Secondary Shaft Assembly Upside Down, And Set The Dial Indicator On The 1st
Gear
5. Hold the secondary shaft, and measure the 1st gear axial clearance in at least three places while moving
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
the 1st gear (A). Use the average as the actual clearance.
Standard: 0.04-0.12 mm (0.002-0.005 in.)
Fig. 77: Measuring The 1st Gear Axial Clearance In At Least Three Places While Moving The 1st
Gear
6. If the clearance is out of standard, remove the 40 x 51.5 mm thrust washer and measure its thickness.
7. Select and install a new thrust washer, then recheck.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 78: Thrust Washer Table
8. After replacing the thrust washer, make sure the clearance is within standard.
9. Disassemble the shaft and gears.
IDLER GEAR SHAFT REMOVAL AND INSTALLATION
1. Remove the snap ring (A), cotter retainer (B), and cotter keys (C). Do not distort the snap ring.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст