Acura TSX / Honda Accord CL. Manual — part 96
1. Remove the screws fastening the rear of the door weatherstrip (A), sash, and the door outer molding (B).
NOTE:
z
Once you remove the door outer molding, replace it with a new one
because it will bend during removal.
z
Put on gloves to protect your hands.
z
Take care not to scratch the door.
z
When prying with a flat-tip screwdriver, wrap it with protective tape to
prevent damage.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Fig. 60: Removing The Screws Fastening The Rear Of The Door Weatherstrip
2. Pry the front clip with a flat-tip screwdriver.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Fig. 61: Prying The Front Clip
3. While removing the upper edge of the door outer molding (A) from the edge of the sash, cut the double-
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
sided adhesive tapes (B) with a utility knife, then remove the molding.
4. Scrape off the remaining double-sided adhesive tape from the sash, then clean the sash surface with a
sponge dampened in alcohol.
5. Install new door outer molding in the reverse order of removal, and note these items.
z
Push the clip and the adhesive portions into place securely.
z
Make sure the upper and lower sides of the molding are catching the edges of the sash properly.
z
Make sure the seal (C) at the bottom of the molding is under the door glass outer weatherstrip (D).
REAR DOOR WEATHERSTRIP REPLACEMENT
1. At the B-pillar, remove the door stop mounting bolt (A).
NOTE:
z
Take care not to scratch the door.
z
Use a clip remover to remove the clips.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст