Acura TSX / Honda Accord CL. Manual — part 367
Fig. 1: Identifying Component Locations
Courtesy of AMERICAN HONDA MOTOR CO., INC.
TROUBLE SHOOTING
STARTER CIRCUIT TROUBLE SHOOTING
2004 Acura TSX
2004 STARTING & CHARGING SYSTEMS Starter - TSX
Recommended Procedure
Manufacturer recommends to use a starter system tester. Connect and operate the equipment in accordance with
the manufacturer's instructions. For starter circuit trouble shooting procedure chart, see Fig. 2 .
NOTE:
z
Air temperature must be between 59° and 100°F (15° and 38°C) during this
procedure.
z
After this test, or any subsequent repair, reset the Engine Control Module
(ECM)/Powertrain Control Module (PCM) to clear any codes.
z
The battery must be in good condition and fully charged.
2004 Acura TSX
2004 STARTING & CHARGING SYSTEMS Starter - TSX
Fig. 2: Starter Circuit Troubleshooting Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 STARTING & CHARGING SYSTEMS Starter - TSX
SYMPTOM TROUBLESHOOTING
For symptom troubleshooting chart, see Fig. 3 .
Fig. 3: Symptom Troubleshooting Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
ON-VEHICLE TESTING
CLUTCH INTERLOCK SWITCH TEST
1. Disconnect the clutch interlock switch 2 pin connector (A). See Fig. 4 .
2. Remove the clutch interlock switch (B).
3. Check for continuity between the terminals according to the table. See Fig. 5 . If the continuity is not as
specified, replace the clutch interlock switch. If OK, install clutch interlock switch and adjust the pedal
height. See appropriate CLUTCHES article in TRANSAXLE/TRANSMISSION.
2004 Acura TSX
2004 STARTING & CHARGING SYSTEMS Starter - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст