Acura TSX / Honda Accord CL. Manual — part 718
Fig. 25: Pressing Pump Drive Shaft Into The Pump Housing
22. Install the 40 mm snap ring (C) with its radiused edge facing out.
23. Coat the NEW 23.8 mm O-ring (A) with the power steering fluid, then position it on the bottom (B) of
the pump housing.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 26: Installing The NEW 23.8 mm O-Ring
24. Coat the NEW cover seals (A) and (B) with the power steering fluid, then position them into the grooves
on the cover (C).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 27: Installing The NEW Cover Seals
25. Install the outer case (A) by aligning the slot (B) inside the outer case with the cover roll pin hole (C). Be
sure that the slit (D) on the outer case is to direction shown.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 28: Installing The Outer Case
26. Apply the power steering fluid to the rubber seal (E) (black), and install it in the slot (F) of the outer case.
27. Apply power steering fluid to the slipper seal (G) (white), and install it on top of the rubber seal you just
installed.
28. Install the cam ring (A) with the "." mark (B) facing up. Align the slot (C) with the slot (D) in the outer
case.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст