Acura TSX / Honda Accord CL. Manual — part 716

(E), and plug them. Take care not to spill the fluid on the body or parts. Wipe off any spilled fluid at
once. Do not turn the steering wheel with the pump removed.

6. Cover the opening of the pump with a piece of tape to prevent foreign material from entering the pump.

7. Connect the pump inlet hose and pump outlet hose.

8. Loosely install the pump in the pump bracket with the mounting bolts, then tighten the pump fittings

securely.

9. Install the drive belt (A). Note these item during belt installation:

z

Make sure that the belt is properly positioned on the pulleys (B).

z

Do not get power steering fluid or grease on the auto-tensioner, alternator, A/C compressor, and
drive belt or pulley faces. Clean off any fluid or grease before installation.

Fig. 17: Ensure That The Belt Is Properly Positioned On The Pulleys

2004 Acura TSX

2004 STEERING Power Steering System - TSX

10. Tighten the pump mounting bolts to the specified torque.

11. Fill the reservoir to the upper level line (see FLUID REPLACEMENT ).

PUMP OVERHAUL

EXPLODED VIEW

Replace the pump as an assembly if the parts indicated with asterisk (

*

) are worn or damaged.

Fig. 18: Exploded View Of Pump

2004 Acura TSX

2004 STEERING Power Steering System - TSX

Special Tools Required:

z

Attachment, 32 x 35 mm 07746-0010100

z

Driver 07749-0010000

z

Pulley holder 07ZAB-S5A0100

DISASSEMBLY

1. Remove the power steering pump (see PUMP REPLACEMENT ).

2. Drain the fluid from the pump (see step 1 on FLUID REPLACEMENT ).

3. Hold the power steering pump (A) in a vise with soft jaws (B), hold the pulley (C) with the special tool

(D), and remove the pulley nut (E) and pulley. Be careful not to damage the pump housing with the jaws
of the vise.

Fig. 19: Removing Pulley

4. Remove the inlet joint and O-ring.

NOTE:

Refer to the Exploded View as needed during the following procedure.

2004 Acura TSX

2004 STEERING Power Steering System - TSX

5. Remove the pressure control valve cap, O-ring, valve spring, and pressure control valve.

6. Remove the pump housing cap, O-ring, and pump preload spring.

7. Remove the pump cover and pump cover seals.

8. Pull out the roll pin.

9. Remove the outer case, cam ring, rotor, vanes, and side plate.

10. Remove the rubber seal and slipper seal from the outer case.

11. Remove the O-rings from the bottom of the housing.

12. Remove the snap ring, then remove the drive shaft by tapping the shaft end with the plastic hammer.

13. Remove the seal from the pump housing.

Inspection

14. Check the pressure control valve for wear, burrs, and other damage to the edges of the edges of the

grooves in the valve.

Fig. 20: Checking The Pressure Control Valve

15. Inspect the bore of the pressure control valve on the pump housing for scratches and wear.

16. Slip the pressure control valve back in the pump housing, and check that it moves in and out smoothly. If

OK, go to step 17; if not, replace the pump as an assembly. The pressure control valve is not available
separately.

2004 Acura TSX

2004 STEERING Power Steering System - TSX