Acura TSX / Honda Accord CL. Manual — part 213
Fig. 115: Installing A NEW Stop Rubber & A NEW Lock Washer
78. Hold the flat surface sections of the steering rack with a wrench, and tighten both rack ends. Be careful
not to damages the rack surface with the wrench.
79. Bend the lock washer (A) back against the flat spots on the rack end joint housing.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 116: Bending The Lock Washer Back Against The Flat Spots On The Rack End Joint Housing
80. Apply multipurpose grease to the circumference of the rack end joint housing (A).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 117: Applying Multipurpose Grease To The Circumference Of The Rack End Joint Housing &
Boot Grooves On The Rack Ends
81. Apply a light coat of silicone grease to the boot grooves (B) on the rack ends.
82. Center the steering rack within its stroke.
83. Clean off the any grease or contamination from the boot installation grooves (A) around on the gearbox
housing. Install the boots (B) on the rack ends with the tie-rod clips (C), and fit the boot end in the
installation grooves in the housing properly.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 118: Installing The Boots
84. After installing the boots, wipe the grease off the threaded section (D) of the rack end.
85. Install the NEW boot bands by aligning the tabs (A) with the holes (B) of the band.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст