Acura TSX / Honda Accord CL. Manual — part 920
Fig. 27: Installing The Clutch Disc
3. Apply a light coat of super high temp urea grease (P/N 08798-9002) to the crankshaft pilot bushing (A).
4. Apply super high temp urea grease (P/N 08798-9002) to the splines (B) of the clutch disc (C), then install
the clutch disc using the special tools.
5. Install the pressure plate (A) and the mounting bolts (B) finger-tight.
2004 Acura TSX
2004 CLUTCHES TSX
Fig. 28: Installing The Pressure Plate
6. Torque the mounting bolts in a crisscross pattern. Tighten the bolts in several steps to prevent warping the
diaphragm spring.
PRESSURE PLATE MOUNTING BOLT TORQUE: 25 N.m (2.6 kgf.m, 19 lbf.ft)
2004 Acura TSX
2004 CLUTCHES TSX
2004 Acura TSX
2004 CLUTCHES TSX
Fig. 29: Torquing The Mounting Bolts In A Crisscross Pattern
7. Remove the special tools.
8. Make sure the diaphragm spring fingers are all the same height.
Release Bearing Replacement
1. Remove the release fork boot (A) from the clutch housing (B).
Fig. 30: Removing The Release Fork Boot From The Clutch Housing
2. Remove the release fork (C) from the clutch housing by squeezing the release fork set spring (D) with
pliers. Remove the release bearing (E).
3. Check the play of the release bearing by spinning it with your hand. If there is excessive play, replace the
release bearing.
NOTE:
The release bearing is packed with grease. Do not wash it in solvent.
2004 Acura TSX
2004 CLUTCHES TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст