Acura TSX / Honda Accord CL. Manual — part 206

Fig. 88: Removing The Four Seal Rings From The Sleeve

25. Using a cutter or an equivalent tool, cut the valve seal ring (A) and O-ring (B) at the cutting groove

position (C) in the pinion shaft. Remove the valve seal ring and O-ring. Be careful not to damage the
edges of the pinion shaft groove and outer surface when removing the valve seal ring and O-ring.

2004 Acura TSX

2004 STEERING Power Steering System - TSX

Fig. 89: Removing The Valve Seal Ring & O-Ring

26. Remove the valve oil seal (A) and wave washer (B) from the pinion shaft. Note these items during

disassembly:

z

Inspect the ball bearing (C) by rotating the outer race slowly. If there is any excessive play or wear,
replace the pinion shaft and sleeve as an assembly.

z

The pinion shaft and sleeve are a precise fit; do not intermix old and NEW pinion shafts and
sleeves.

2004 Acura TSX

2004 STEERING Power Steering System - TSX

Fig. 90: Removing The Valve Oil Seal And Wave Washer From The Pinion Shaft

27. Press the valve oil seal (A) and roller bearing (B) out of the valve housing using a hydraulic press and

special tool.

2004 Acura TSX

2004 STEERING Power Steering System - TSX

Fig. 91: Pressing The Valve Oil Seal And Roller Bearing Out Of The Valve Housing

28. Clean the disassembled parts with solvent, and dry them with compressed air. Do not dip rubber parts in

the solvent.

Reassembly

29. Apply vinyl tape (A) to the stepped portion of the pinion shaft, and coat the surface of the vinyl tape with

power steering fluid.

2004 Acura TSX

2004 STEERING Power Steering System - TSX