Acura TSX / Honda Accord CL. Manual — part 205
Fig. 84: Pressing Valve Housing From The Pinion Shaft/Valve
20. Separate the valve housing from the pinion shaft/valve using a press.
21. With your finger, check the inner wall of the valve housing where the seal ring slides. If there is a step in
the wall, the housing is worn. Replace it.
NOTE:
There may be sliding marks from the seal ring on the wall of the valve
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 85: Checking The Inner Wall Of The Valve Housing
22. Check for wear, burrs, and other damage to the edges of the grooves in the sleeve.
housing. Replace the valve housing only if the wall is stepped.
NOTE:
The pinion shaft and sleeve are a precision matched set. If either the
pinion shaft or sleeve must be replaced, replace both parts as a set.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 86: Checking The Edges Of The Grooves In The Sleeve
23. Remove the snap ring (A) and sleeve (B) from the pinion shaft.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 87: Removing The Snap Ring & Sleeve From The Pinion Shaft
24. Using a cutter or an equivalent tool, cut and remove the four seal rings from the sleeve. Be careful not to
damage the edges of the sleeve grooves and outer surface when removing the seal rings.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст