Acura TSX / Honda Accord CL. Manual — part 191
Fig. 30: Installing The Rotor In The Cam Ring & Vanes In The Grooves In The Rotor
31. Set the 11 vanes (C) in the grooves in the rotor. Make sure that the round ends (D) of the vanes are in
contact with the sliding surface of the cam ring.
32. Place the side plate (A) on the cam ring, and aligning the roll pin set hole (B) in the side plate with the
roll pin end (C).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 31: Placing The Side Plate On The Cam Ring
33. Coat the NEW O-ring (D) with the power steering fluid, then position it into the groove on the side plate.
34. Install the pump housing (A) over the cover assembly (B).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 32: Installing The Pump Housing Over The Cover Assembly
35. Align the bolt holes in the cover (A) with the threaded holes in the pump housing. Install the flange bolts
loosely first, then torque the flange bolts in a crisscross pattern in two or more steps.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 33: Aligning The Bolt Holes In The Cover With The Threaded Holes In The Pump Housing
36. Push in the cam ring (A) from the pump housing cap hole (B) with a flat blade screwdriver, to make sure
the cam ring is fully seated against the outer case.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст