Acura TSX / Honda Accord CL. Manual — part 742
Fig. 118: Installing The Boots
84. After installing the boots, wipe the grease off the threaded section (D) of the rack end.
85. Install the NEW boot bands by aligning the tabs (A) with the holes (B) of the band.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 119: Installing The NEW Boot Bands
86. Close the ear portion (A) of the band (B) with commercially available pincers, Oetiker 1098 or equivalent
(C).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 120: Closing The Ear Portion Of The Band
87. Slide the rack right and left to be certain that the boots are not deformed or twisted.
STEERING GEARBOX INSTALLATION
2004 Acura TSX
2004 STEERING Power Steering System - TSX
1. Before installing the steering gearbox, make sure that no power steering fluid is on the mating surface of
the gearbox and a front suspension subframe. To prevent the gearbox mounting bolts from loosening after
the installation, remove the power steering fluid from the mount cushions and bolt holes.
2. Apply a mild soap and water solution to both side of the mount cushion mating surfaces (A).
Fig. 121: Apply A Mild Soap & Water Solution To Both Sides Of The Mount Cushion Mating
Surfaces & Pass The Steering Gearbox Through The Wheelwell Opening On The Driver's Side
3. Pass the cylinder of the steering gearbox (B) through the wheelwell opening on the driver's side.
4. Carefully move the steering gearbox toward the passenger's side until the pinion shaft clears the
wheelwell opening on the body.
5. Rotate the steering gearbox so the pinion shaft (A) points upward.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст