Acura TSX / Honda Accord CL. Manual — part 472
Fig. 264: Installing The Harness Holder, Bracket & Clamp
6. Reconnect the MAP sensor and throttle actuator connectors.
7. Install the evaporative emission (EVAP) canister hose (A) and brake booster vacuum hose (B).
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 265: Installing The Hoses
8. Install the intake manifold cover.
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 266: Installing The Intake Manifold Cover
9. Install the intake air duct (A), then connect the intake air temperature (IAT) sensor connector (B), and
install the vacuum hose (C) and breather pipe (D).
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 267: Installing The Intake Air Duct
10. Clean up any spilled engine coolant.
11. After installation, check that all tubes, hoses and connectors are installed correctly.
12. Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open
(see COOLANT REPLACEMENT ).
EXHAUST MANIFOLD REMOVAL & INSTALLATION
1. Remove the VTEC solenoid valve (see REMOVAL & INSTALLATION ).
2. Remove the cover and exhaust manifold bracket, then remove the exhaust manifold.
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст