Acura TSX / Honda Accord CL. Manual — part 665
Is there battery voltage?
YES: Check for loose wires or poor connections at terminal E12 of the ECM/PCM connector
E (31P). If the connections are good, substitute a known-good ECM/PCM, and recheck. If
the symptom/indication goes away, replace the original ECM/PCM (see HOW TO
REMOVE THE ECM/PCM FOR TESTING ).
NO: Repair open in the wire between the radiator fan relay, the condenser fan relay, and the
ECM/PCM.
Fig. 77: Measuring The Voltage Between The No. 12 Terminal Of ECM/PCM Connector E
(31P) & Body Ground (ECM/PCM Connectors Connected)
2004 Acura TSX
2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX
COMPRESSOR CLUTCH CIRCUIT TROUBLESHOOTING
1. Check the No. 9 (20A) fuse in the under-hood fuse/relay box, and the No. 30 (7.5A) fuse in the under-
dash fuse/relay box.
Are the fuses OK?
YES: Go to step 2.
NO: Replace the fuse(s), and recheck.
2. Check the engine coolant temperature, throttle position, and idle speed (use the HDS PGM-FI data list if
possible).
Is the coolant temperature, throttle position, and idle speed OK?
YES: Go to step 3.
NO: Troubleshoot and repair the cause of the high engine coolant temperature, low idle, or
excessively high throttle position sensor reading.
Fig. 78: Coolant Temperature, Throttle Position & Idle Speed Test Specifications Table
3. Remove the compressor clutch relay from the under-hood fuse/relay box, and test it (see POWER
RELAY TEST ).
Is the relay OK?
YES: Go to step 4.
NOTE:
After replacing the ECM/PCM, do the following items:
z
ECM/PCM idle learn procedure (see ECM/PCM IDLE LEARN
PROCEDURE ).
z
Enter the anti-theft codes for the radio and navigation system, then
enter the customer's radio station presets.
z
Replace ECM/PCM procedure with HDS.
NOTE:
Do not use this troubleshooting procedure if the fans are also inoperative, refer
to the symptom troubleshooting index.
2004 Acura TSX
2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX
NO: Replace the compressor clutch relay.
4. Measure the voltage between the No. 1 terminal of the compressor clutch relay 4P socket and body
ground.
Is there battery voltage?
YES: Go to step 5.
NO: Replace the under-hood fuse/relay box.
Fig. 79: Measuring The Voltage Between The No. 1 Terminal Of The Compressor Clutch
Relay 4P Socket & Body Ground
5. Connect the No. 1 and No. 2 terminals of the compressor clutch relay 4P socket with a jumper wire.
Does the compressor clutch click?
YES: Go to step 6.
NO: Go to step 14 .
2004 Acura TSX
2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX
Fig. 80: Connecting The No. 1 & No. 2 Terminals Of The Compressor Clutch Relay 4P Socket
With A Jumper Wire
6. Disconnect the jumper wire.
7. Turn the ignition switch ON (II).
8. Measure the voltage between the No. 4 terminal of the compressor clutch relay 4P socket and body
ground.
Is there battery voltage?
YES: Go to step 9.
NO: Repair open in the BLK/YEL wire between the No. 30 fuse in the under-dash fuse/relay
box and the compressor clutch relay.
2004 Acura TSX
2004 AUTOMATIC A/C SYSTEMS Climate Control System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст