Acura CSX. Manual — part 419
*02
20-4
Doors
GLASS RUN CHANNEL
GLASS
SPACER
OUTER HANDLE
PROTECTOR
DOOR CYLINDER (Driver’s)
RETAINER
INNER HANDLE
INNER HANDLE CAP
LATCH CABLE
LATCH
LATCH PROTECTOR
STRIKER
INNER HANDLE CABLE
CENTER LOWER CHANNEL
REGULATOR
OUTER HANDLE
Replacement, page 20-14
Adjustment, page 20-28
Replacement, page 20-12
Adjustment,
page 20-31
Replacement,
page 20-14
Replacement,
page 20-9
08/08/21 14:58:53 61SNR030_200_0006
*01
SNR9A00J16166200000DAAT00
20-5
Component Location Index - Rear Door
DOOR ROOF OUTER TRIM
DOOR CENTER OUTER TRIM
DOOR
HINGE
DOOR CHECKER
HINGE
DOOR PANEL
POWER WINDOW SWITCH
SWITCH PANEL
ARMREST
DOOR WEATHERSTRIP
PLASTIC COVER
DOOR GLASS
INNER WEATHERSTRIP
DOOR GLASS OUTER WEATHERSTRIP
Position Adjustment, page 20-29
Removal/Installation,
page 20-17
Replacement, page 20-27
Replacement, page 20-26
08/08/21 14:58:54 61SNR030_200_0007
*02
20-6
Doors
QUARTER GLASS
QUARTER SEAL
GLASS
GLASS RUN CHANNEL
REGULATOR
OUTER HANDLE
LATCH
STRIKER
REAR LOWER CHANNEL
INNER HANDLE CABLE
INNER HANDLE CAP
INNER HANDLE
LATCH CABLE
OUTER HANDLE
PROTECTOR
LATCH PROTECTOR
Replacement, page 20-23
Replacement, page 20-23
Adjustment, page 20-28
Replacement, page 20-23
Replacement,
page 20-19
Replacement, page 20-21
Adjustment, page 20-21
08/08/21 14:58:56 61SNR030_200_0008
01
01
*01
04
SNR9A00J16126721401KDAT10
Special Tools Required
20-7
Front Door Panel Removal/Installation
A
B
C
Fastener Locations
: Screw, 1
: Clip, 1
A
Fastener Location
: Clip, 1
A
B
C
D
B
E
A
Fastener Location
: Screw, 1
KTC trim tool set SOJATP2014
NOTE: Use the appropriate tool from the KTC trim tool
set to avoid damage when removing components.
1. Raise the glass fully.
2. Pry out on the rear portion of the inner handle cap
(A) with the appropriate trim tool, then release the
hooks (B, C).
3. Remove the screw and the clip securing the inner
handle (A).
4. Remove the power window switch panel (A).
–1 Pry up on the rear edge of the switch panel
with the appropriate trim tool, then release the
rear clip.
–2 Pull out along the edge of the panel to release
all of the hooks (B).
–3 Pull the switch panel rearward to release the
front hook (C).
–4 Disconnect the power mirror switch connector
(D) (driver’s) and the power window switch
connector (E).
5. Remove the screw.
08/08/21 14:58:57 61SNR030_200_0009
07AAC-SEPA240
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст