Acura CSX. Manual — part 289
14
15
16
17
14-237
A
B
C
A
B
C
25. Remove the steering gearbox bracket mounting
bolts.
26. Remove the steering gearbox mounting bolt (A),
the stiffener mounting bolt (B), and the stiffener (C).
27. Remove the steering gearbox mounting bolt (A),
the stiffener mounting bolt (B), and the stiffener (C).
28. Remove the bolt securing the harness clamp
bracket.
08/08/21 14:46:56 61SNR030_140_0239
18
19
20
21
14-238
Automatic Transmission
A
B
C
C
B
A
29. Remove the ATF cooler hose from the ATF cooler.
30. Remove the exhaust pipe rubber mount.
31. Remove the lower torque rod bolt.
32. Make appropriate lines (A) on the front subframe
(B) that line up with the edge (C) of the body.
08/08/21 14:46:57 61SNR030_140_0240
22
23
24
25
14-239
VSB02C000016
A
B
C
A
B
C
D
E
F
33. Attach the front subframe adapter (VSB02C000016)
to the front subframe by looping the strap (A) over
the front of the front subframe, then secure the
strap with the stop (B), then tighten the wing nut (C).
34. Raise a jack and line up the slots in the arms with
the bolt holes on the corner of the jack base, then
tighten the bolts.
35. Remove the four bolts securing the front subframe,
and lower the front subframe.
36. Secure the steering gearbox to the body with a
rope.
37. Remove the driveshafts from the differential and
the intermediate shaft. Coat all precision machined
surfaces with clean engine oil, then put plastic bags
over the driveshaft ends.
38. Remove the three bolts securing the shift cable
holder (A), then remove the shift cable cover (B).
39. Pry up the lock tab of the lock washer (C), and
remove the lock bolt (D) and the lock washer, then
separate the shift cable (E) from the selector control
shaft (F). Do not bend the shift cable excessively.
08/08/21 14:48:40 61SNR030_140_0241
26
27
28
29
14-240
Automatic Transmission
A
B
A
B
40. Remove the torque converter cover (A), and
remove the drive plate bolts (B) (8) while rotating
the crankshaft pulley.
41. Remove the intermediate shaft cover (A).
42. Remove the intermediate shaft (B). Coat all
precision finished surfaces with clean engine oil,
then tie the plastic bags over the intermediate shaft
ends.
43. Remove the upper transmission housing mounting
bolts.
44. Remove the transmission mount bracket bolts.
08/08/21 14:48:41 61SNR030_140_0242
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст