Acura CSX. Manual — part 78
03
04
05
10-17
5. Remove the air cleaner brackets.
6. Remove the water outlet.
7. Remove the EGR plate.
08/08/21 14:40:04 61SNR030_100_0017
06
07
08
09
Installation - K20Z3 engine
10-18
Cooling System
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
A
B
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
A
B
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
A
B
C
1. Install the EGR plate (A) with a new gasket (B).
2. Install the water outlet (A) with a new gasket (B).
3. Install the air cleaner brackets.
4. Connect the upper radiator hose (A), the heater
hose (B), and the water bypass hose (C).
08/08/21 14:40:05 61SNR030_100_0018
10
01
SNR9A00A14400049001KBAT00
10-19
10-19
Radiator and Fan Replacement
B
A
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
B
C
A
C
C
C
5. Install the harness holder bracket (A), then install
the harness holder (B).
6. Install the air cleaner assembly (see page 11-345).
7. Refill the radiator with engine coolant, and bleed
the air from the cooling system with the heater
valve open (see step 6 on page 10-8).
8. Clean up any spilled engine coolant.
1. Do the battery removal procedure (see page 22-69).
2. Drain the engine coolant (see page 10-8).
3. Remove the front grille cover (see page 20-163).
4. Disconnect the fan motor connectors (A) and the
hood switch connector (B), then remove the
harness clamps (C).
08/08/21 14:40:05 61SNR030_100_0019
10
01
SNR9A00A14400049001KBAT00
10-19
10-19
Radiator and Fan Replacement
B
A
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
A
B
C
A
C
C
C
5. Install the harness holder bracket (A), then install
the harness holder (B).
6. Install the air cleaner assembly (see page 11-345).
7. Refill the radiator with engine coolant, and bleed
the air from the cooling system with the heater
valve open (see step 6 on page 10-8).
8. Clean up any spilled engine coolant.
1. Do the battery removal procedure (see page 22-69).
2. Drain the engine coolant (see page 10-8).
3. Remove the front grille cover (see page 20-163).
4. Disconnect the fan motor connectors (A) and the
hood switch connector (B), then remove the
harness clamps (C).
08/08/21 14:40:05 61SNR030_100_0019
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст