Acura CSX. Manual — part 537
*90
−
−
−
−
22-195
R10
LT BLU
K5
G3
E38
CLOSE
OPEN
1
2
(3.4 W)
LT BLU
BLK
GRY
GRY
GRY
RED
(5 W)
1
WHT
2
(LED)
GRN
G502
AMBIENT
LIGHT
DASH LIGHTS
BRIGHTNESS
CONTROLLER
TRUNK
LIGHT
UNDER-DASH
FUSE/RELAY BOX
No. 14 (7.5 A) FUSE
(UNDER-DASH
FUSE/RELAY BOX)
GLOVE
BOX
LIGHT
GLOVE
BOX
LID
GRY
(LED)
RED
2
1
DRIVER’S
FOOTWELL
LIGHT
DASH LIGHTS
BRIGHTNESS
CONTROLLER
GRY
(TYPE S model)
BLU
DRIVER’S
DOOR
COURTESY
LIGHT
TRUNK LID
LATCH
SWITCH
GRY
(LED)
RED
2
1
FRONT
PASSENGER’S
FOOTWELL
LIGHT
DASH LIGHTS
BRIGHTNESS
CONTROLLER
LT BLU
DRIVER’S
VANITY
MIRROR
LIGHT
SWITCH
DRIVER’S
VANITY
MIRROR
LIGHT (2 W)
DRIVER’S
SUNVISOR
1
2
LT BLU
PASSENGER’S
VANITY
MIRROR
LIGHT
SWITCH
PASSENGER’S
VANITY
MIRROR
LIGHT (2 W)
PASSENGER’S
SUNVISOR
1
2
G502
BLK
*2
BLK
BLK
No. 22 (7.5 A) FUSE
(UNDER-HOOD
FUSE/RELAY BOX)
C
D
B
5*3
4*4
3*2
2*2
5*4
3*3
*1: ’06 07 models
*2: ’08 09 models
*3: ’06 07 models with moonroof
*4: ’06 07 models without moonroof
08/08/21 14:27:49 61SNR030_220_0197
*01
02
SNR9AB9J32350539851FHAT10
*01
02
SNR9AB8J32350539851FHAT11
With moonroof
Without moonroof
Front Individual Map Light: 8 W x 2
Front Individual Map Light: 8 W x 2
22-196
22-196
Interior Lights
Front Individual Map Light Test/Replacement
A
B
C
Position
1
3
Terminal
RIGHT
LEFT
ON
OFF
ON
OFF
Body
ground
A
B
C
Position
1
Terminal
RIGHT
LEFT
ON
OFF
ON
OFF
Body
ground
1. Turn the map light switch OFF.
2. Carefully pry the lens (A) off with a small
screwdriver.
3. Remove the screws, then remove the map lights (B)
and moonroof switch or navigation microphone (C).
4. Disconnect the 3P connector from the map lights
and the 10P connector from the moonroof switch or
navigation microphone.
5. Check for continuity between the terminals in each
switch position according to the table.
6. If the continuity is not as specified, check the
bulb(s). If the bulb(s) are OK, replace the light
assembly.
7. Install the map light in the reverse order of removal.
1. Turn the map light switch OFF.
2. Carefully pry the lens (A) off with a small
screwdriver.
3. Remove the screws, then remove the map lights (B).
4. Disconnect the 3P connector (C) from the map
lights.
5. Check for continuity between the terminals in each
switch position according to the table.
6. If the continuity is not as specified, check the
bulb(s). If the bulb(s) are OK, replace the light
assembly.
7. Install the map light in the reverse order of removal.
08/08/21 14:27:50 61SNR030_220_0198
01
SNR9A00J32300016301FHAT10
+
−
01
SNR9A00J32373760401FHAT01
+
−
Ceiling Light: 8 W
Trunk Light: 5 W
22-197
22-197
Ceiling Light Test/Replacement
Trunk Light Test/Replacement
A
C
B
A
B
(
)
(
)
1. Turn the ceiling light switch OFF.
2. Carefully pry the lens (A) off with a small
screwdriver.
3. Remove the screws, then remove the ceiling light
(B).
4. Disconnect the 3P connector (C) from the ceiling
light.
5. Check for continuity between the terminals.
• There should be continuity between terminals
No. 1 and No. 2 with the switch in the MIDDLE
position.
• There should be continuity between terminals
No. 2 and No. 3 (Body ground) with the switch in
the ON position.
• There should be no continuity between terminals
No. 1 and No. 2, and between No. 2 and body
ground with the switch in the OFF position.
6. If the continuity is not as specified, check the bulb.
If the bulb is OK, replace the light.
7. Install the ceiling light in the reverse order of
removal.
1. Open the trunk lid.
2. Carefully pry out the trunk light (A).
3. Disconnect the 2P connector (B) from the light.
4. Check for continuity between terminals No. 1 (
)
and No. 2 (
). There should be continuity. If there
is no continuity, check the bulb. If the bulb is OK,
replace the trunk light assembly.
5. Install the trunk light in the reverse order of
removal.
08/08/21 14:27:50 61SNR030_220_0199
*01
SNR9A00J32300012932FHAT00
01
SNR9A00J32320520101KBAT00
Courtesy light:3.4 W
22-198
22-198
Interior Lights
Ambient Light Test/Replacement
Courtesy Light Replacement
A
B
C
’06-07 models
’08-09 models
A
B
C
D
1. Remove the front individual map light.
• With moonroof (see page 22-196)
• Without moonroof (see page 22-196)
2. Disconnect the 10P
(or 12P ) connector (A) from
the ambient light (B), then remove the ambient
light from the front individual map light housing (C).
1: ’06-07 models
2: ’08-09 models
3. Connect battery power to the terminal No. 5 and
ground to the No. 3 terminal. The ambient light
should turn on. If the light does not turn on, replace
the ambient light.
4. Install the ambient light in the reverse order of
removal.
1. Carefully pry off the lens (A) with a small
screwdriver.
2. Pry out the housing (B) from the door panel, then
disconnect the 2P connector (C).
3. Separate the housing, then remove the bulb (D)
from the socket.
4. Install the courtesy light in the reverse order of
removal.
1
2
08/08/21 14:27:50 61SNR030_220_0200
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст