Acura RSX Honda Integra. Manual — part 442
01
01
S6M6A22J32300039851FHAT13
01
02
S6M6A00J32300016301FHAT10
With Moonroof
Spotlight:
8 W x 2
Ceiling Light: 8 W
22-107
22-107
Spotlight Test/Replacement
Ceiling Light Test/Replacement
B
C
A
5 x 1.0 mm
B
C
5 x 1.0 mm
A
Terminal
Position
OFF
3
ON
MIDDLE
1
2
Terminal
Position
OFF
2
ON
LEFT
RIGHT
OFF
ON
1 or
Body
ground
1. Turn the light switch OFF.
2. Carefully pry off the lenses (A) with a small
screwdriver.
3. Remove the two mounting screws.
4. Disconnect the 2P connector (B) from the housing
(C).
5. Check for continuity between the terminals in each
switch position according to the table.
6. If the continuity check is not as specified, check the
bulb(s). If the bulb is OK, replace the housing.
1. Turn the light switch OFF.
2. Carefully pry off the lens (A) with a small
screwdriver.
3. Remove the two mounting screws.
4. Disconnect the 3P connector (B) from the housing
(C).
5. Check for continuity between the terminals in each
switch position according to the table.
6. If the continuity check is not as specified, check the
bulb(s). If the bulb is OK, replace the housing.
Not used
05/06/27 18:04:06 61S6M040_220_0108
+
−
01
S6M6A00J32316816151FHAT00
01
S6M6A00J32316830930FEAT00
+
−
Cargo Area Light: 5 W
22-108
22-108
Interior Lights
Cargo Area Light Test/Replacement
Hatch Latch Switch Test
A
B
C
(
)
(
)
A
B
1. Open the hatch.
2. Carefully pry out the cargo area light (A).
3. Disconnect the 2P connector (B) from the light.
4. Check for continuity between the No. 1 (
) and
No. 2 (
) terminals. There should be continuity.
5. If there is no continuity, check the bulb (C). If the
bulb is OK, replace the cargo area light.
1. Open the hatch.
2. Remove the hatch trim panel (see page 20-54).
3. Disconnect the 2P connector (A) from the hatch
latch (B).
4. Check for continuity between the No. 1 and No. 2
terminals.
• There should be continuity with the hatch open.
• There should be no continuity with the hatch
closed.
5. If the continuity check is not as specified, replace
the switch.
Terminal side
of male
terminals
05/06/27 18:04:07 61S6M040_220_0109
01
S6M6A00J32300014561KBAT00
01
S6M6A00J32300030111FHAT00
Beverage Holder Light:
1.4 W
Glove Box Light:
3.4 W
22-109
22-109
Beverage Holder Light Replacement
Glove Box Light Test/Replacement
B
A
A
1. Remove the dashboard center lower cover
(see page 20-65).
2. Remove the audio unit (see page 22-118).
3. Disconnect the 2P connector (A) from the beverage
holder light (B), then remove the beverage holder
light from the dashboard.
4. Install in the reverse order of removal.
1. Open the glove box.
2. Disconnect the 2P connector from the glove box
light (A).
3. Check for continuity between the No. 1 and No. 2
terminals.
• There should be continuity with the switch
released.
• There should be no continuity with the switch
pushed.
4. If the continuity check is not as specified, replace
the glove box light.
05/06/27 18:04:07 61S6M040_220_0110
*01
S6M6A00J10300000000DAAT00
22-110
Audio System
Component Location Index
LEFT TWEETER
ANTENNA SUBLEAD
RIGHT TWEETER
AUDIO UNIT
PASSENGER’S
DOOR SPEAKER
FRONT STEREO AMPLIFIER
RIGHT REAR SPEAKER
*
*
DRIVER’S DOOR SPEAKER
ANTENNA LEAD
LEFT REAR SPEAKER
WINDOW ANTENNA
WOOFER
*
REAR STEREO AMPLIFIER
*
REAR STEREO AMPLIFIER RELAY
Replacement,
page 22-121
Replacement, page 22-121
Removal, page 22-118
Connector Terminals, page 22-114
Replacement, page 22-120
Replacement, page 22-122
Connector Terminals, page 22-116
Replacement, page 22-121
Replacement, page 22-120
Replacement, page 22-121
Test, page 22-124
Repair, page 22-124
Replacement, page 22-123
Replacement, page 22-123
Connector Terminals, page 22-117
Wire colors: BLU/RED, BLK,
WHT and BRN
Test, page 22-62
*: With BOSE sound system
05/06/27 18:04:10 61S6M040_220_0111
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст