Acura RSX Honda Integra. Manual — part 217
*01
S6M6AALE34150700000DAAT00
2005-2006 models:
13-83
BALL BEARING
FINAL DRIVEN GEAR
DIFFERENTIAL CARRIER
BALL BEARING
Replacement, page 13-85
Replacement, page 13-84
Backlash Inspection, page 13-84
Replacement, page 13-84
Replacement, page 13-85
05/06/27 18:11:24 61S6M040_130_0083
01
S6M6A01E34150719642MAAT00
01
S6M6A01E34150727002KBAT00
−
−
Standard (New): 0.05
0.15 mm (0.002
0.006 in.)
13-84
13-84
M/T Differential
Backlash Inspection
Differential Carrier, Final Driven
Gear Replacement
A
B
C
11 x 1.0 mm (10)
121 N·m
(12.3 kgf·m,
89 lbf·ft)
A
B
1. Place the differential assembly on V-blocks (A), and
install both axles.
2. Measure the backlash of both pinion gears (B) with
a dial indicator (C). If the backlash is not within the
standard, replace the differential carrier.
1. Remove the bolts (left-hand threads) in a crisscross
pattern in several steps, then remove the final
driven gear (A) from the differential carrier (B).
2. Install the final driven gear with the chamfer on the
inside diameter facing the carrier. Tighten the bolts
in a crisscross pattern in several steps.
05/06/27 18:11:25 61S6M040_130_0084
01
02
*01
*02
S6M6A01E34150719612KBAT00
Special Tools Required
13-85
Carrier Bearing Replacement
A
B
A
B
A
B
A
B
07746-0030100
07746-0030100
Driver, 40 mm I.D. 07746-0030100
1. Check the carrier bearings for wear and rough
rotation. If they rotate smoothly and their rollers
show no signs of wear, the bearings are OK.
2. Remove the carrier bearing (A) with a
commercially-available bearing puller (B).
3. Install the new bearings (A) with the special tool
and a press. Press on each bearing until it bottoms.
There should be no clearance between the bearings
and the carrier.
NOTE: Place the seal part of the bearing (B)
towards the outside of the differential, then install it.
05/06/27 18:11:25 61S6M040_130_0085
01
02
01
02
S6M6A01E34150719632KBAT00
Special Tools Required
13-86
M/T Differential
Oil Seal Replacement
A
B
A
B
07749-0010000
07NAD-P20A100
07749-0010000
07NAD-P20A100
• Driver 07749-0010000
• Oil seal driver attachment 07NAD-P20A100
1. Remove the differential assembly.
2. Remove the oil seal (A) from the transmission
housing (B).
3. Remove the oil seal (A) from the clutch housing (B).
4. Install the new oil seal in the transmission housing
with the special tools.
5. Install the new oil seal in the clutch housing with
the special tools.
05/06/27 18:11:26 61S6M040_130_0086
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст