Acura RSX Honda Integra. Manual — part 36
20
*01
02
*02
M/T
2002-2003 Models:
2004-2006 Models:
A/T
2002-2003 Models:
2004-2006 Models:
5-8
Engine Assembly
Engine Removal (cont’d)
42. Remove the transmission mount bracket support
bolt/nuts.
21
22
*03
Except 2005-2006 TYPE S Models:
2005-2006 TYPE S Models:
5-9
43. Remove the upper bracket mounting bolt and nut.
44. Make sure the hoist brackets are positioned
properly. Raise the hoist to full height.
45. Remove the rear mount mounting bolts.
(cont’d)
23
24
25
5-10
Engine Assembly
Engine Removal (cont’d)
C
A
B
A
B
B
A
46. Remove the front mount bracket mounting bolt.
47. Use a marker to make alignment marks on the
reference lines (A) that align with the centers of the
rear subframe mounting bolts (B).
48. Remove the front subframe (C).
49. Disconnect the compressor clutch connector (A),
then remove the A/C compressor (B) without
disconnecting the A/C hoses.
50. Check that the engine/transmission is completely
free of vacuum hoses, fuel and coolant hoses, and
electrical wiring.
51. Slowly lower the engine about 150 mm (6 in.).
Check once again that all hoses and wires are
disconnected from the engine/transmission.
52. Lower the engine all the way. Remove the chain
hoist from the engine.
53. Remove the engine from under the vehicle.
01
S6M6A00A18223800000KCAT00
5-11
Engine Installation
SIDE ENGINE MOUNT
BRACKET
A/C COMPRESSOR
BRACKET
10 x 1.25 mm
44 N·m
(4.5 kgf·m, 33 lbf·ft)
10 x 1.25 mm
44 N·m
(4.5 kgf·m, 33 lbf·ft)
1. Install the accessory brackets, and tighten their bolts to the specified torques.
(cont’d)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст