DAF 95XF. Manual — part 606
8
TRAILING AXLES
Removal and installation
3-18
5.
Loosen the nuts (1, 2, 4 and 5) of the
push/pull rod (3).
1
2
3
4
5
A8 00 407
6.
Mark the bearing blocks in relation to the
bearing support.
A800210
7.
Remove the attachment nuts from the
bearing block. Remove the bearing support
from the bearing blocks.
A8 00 410
5
ǹ 200302
8
Removal and installation
TRAILING AXLES
3-19
8.
Remove the adjusting nut from the bearing
block.
A8 00 420
9.
Remove the outer nut (1) of the push/pull
rod (3).
1
2
3
4
5
A8 00 407
10. Use two band irons to remove the outer
bearing block from the axle journal.
The bearing cage of the roller bearing will
remain on the axle journal and retain the oil
seal.
A800214
ǹ 200302
5
8
TRAILING AXLES
Removal and installation
3-20
11. Remove the bearing cage from the axle
journal. Remove the oil seal from the axle
journal.
A8 00 417
12. Similarly remove the inner bearing block
with bearing and oil seal from the axle
journal.
13. Tap the sealing plate off the inner bearing
from inside the bearing block, if the outer
race of the roller bearing must be removed.
A8 00 418
5
ǹ 200302
8
Removal and installation
TRAILING AXLES
3-21
Installing the trailing axle yoke
1.
Clean the axle journals and bearing blocks.
2.
Clean and check all bearings for wear and
damage.
3.
Apply new grease to the bearings.
4.
Fit the bearing in the inner bearing block.
5.
Fit the seals at the indicated positions in the
bearing blocks.
A8 00 423
6.
Lightly grease the axle journals.
7.
Fit the inner bearing block to the axle
journal.
A8 00 422
ǹ 200302
5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст