DAF LF45, LF55 Series. Manual — part 275

©

200508

4-3

Demounting and mounting

PROP SHAFTS

ΛΦ45/55 series

3

10

1.

Fit the sealing rings in their proper positions

on the bearings and lubricate them lightly so

that the needles remain in place.

2.

Press one bearing partly into the drive

flange.

3.

Tip the spider into the drive flange.

Note:

Maintenance-free spiders do not have a

mounting direction. In the case of spiders

fitted with lubricating nipples, hole A for the

lubricating nipple must point towards the

shaft.

4.

Slide the spider a little into the fitted bearing

and place everything on a bush underneath

a press. The opposite bearing can now be

pressed into the fork, the spider serving as a

guide. During the pressing action, the spider

must be able to move freely.

A

W306014-2

W306017-2

PROP SHAFTS

4-4

©

200508

Demounting and mounting

10

ΛΦ45/55 series

3

5.

Continue to press the bearing until a Seeger

ring can be fitted on the side being pressed.

Fit the Seeger ring and press the opposite

bearing further into the fork. Again, the

Seeger ring can now be fitted.

6.

Fit the sealing rings in their proper positions

on the prop shaft bearings and lubricate

them lightly so that the needles remain in

place.

7.

Press one bearing partly into the prop shaft.

8.

Slide the spider a little into the fitted bearing

and place everything on a bush underneath

a press. The opposite bearing can now be

pressed into the fork, the spider serving as a

guide. During the pressing action, the spider

must be able to move freely.

9.

Continue to press the bearing until a Seeger

ring can be fitted on the side being pressed.

Fit the Seeger ring and press the opposite

bearing further into the fork. Again, the

Seeger ring can now be fitted.

10. Fit the circlips and the attachment bolts of the

clamping pieces (1).

11. Install the prop shaft and/or intermediate

shaft.

W306013-2

V3 00 377

1

©

200508

4-5

Demounting and mounting

PROP SHAFTS

ΛΦ45/55 series

3

10

4.2 DISASSEMBLY AND ASSEMBLY, UNIVERSAL JOINT

Disassembly, universal joint
1.

Remove the prop shaft and/or intermediate

shaft assembly.

2.

If fitted, remove the lubricating nipple and all

Seeger rings from the spider to be replaced.

W306009-2

PROP SHAFTS

4-6

©

200508

Demounting and mounting

10

ΛΦ45/55 series

3

3.

Place the shaft on a bush underneath a

press, as shown, and press the entire spider

including bearings and drive flange down

until the spider touches the fork of the shaft.

4.

Rotate the shaft 180

″ and remove the

bearing that has just been pressed out. If the

first bearing to be removed fails to come out

of the fork entirely, the bearing can be

clamped to enable the fork to be pushed up

by means of a lever. Place the shaft back on

the bush.

W306010-2

W306012-2