DAF LF45, LF55 Series. Manual — part 649
©
200515
3-25
Inspection and adjustment
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΛΦ45/55 series
5
3.31 CHECKING THE TRAILER COUPLING
1.
Check the vertical play of the arched pin.
2.
Check the radial play of the arched pin.
3.
Check the vertical and horizontal play of the
coupling jaw.
4.
Check the diameter of the arched pin.
5.
Check the attachment of the trailer coupling
and the rear cross member.
Note:
For maximum play values, consult the
manufacturer’s instructions or the specified
legal requirements.
M9002
M9001
M9004
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
3-26
©
200515
Inspection and adjustment
5
ΛΦ45/55 series
3.32 CHECK THE SUPERSTRUCTURE ATTACHMENT
1.
Check that all attachment bolts are in place.
2.
Visually check the attachment of the
superstructure for faults. See the DAF
superstructure instructions.
©
200515
3-27
Inspection and adjustment
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΛΦ45/55 series
5
3.33 CHECK THE CLUTCH FLUID LEVEL
Hydraulic fluid is toxic and can
therefore have a damaging effect on
your health.
Hence avoid any direct or indirect
physical contact.
In the event of contact with the skin:
remove the liquid with paper or a
cloth, wash with soap and water. If
irritation persists, consult a doctor.
If swallowed: DO NOT induce
vomiting. Rinse mouth, drink two
glasses of water and consult a
doctor.
In the event of inhalation: get fresh
air and rest.
As hydraulic fluid is also a corrosive
fluid, it may damage the paintwork of
the vehicle. Avoid any contact
between hydraulic fluid and
paintwork.
Always use new and clean hydraulic
fluid which has been kept in a sealed
container and meets the
specifications.
Hydraulic fluid which has absorbed
water (from the ambient air) may
have an adverse effect on the
operation of the clutch system.
Avoid any contact with mineral oil.
Even one drop of mineral oil in the
system will damage the seals.
1.
Check whether the fluid level is between the
min and max marks when the cab is in the
driving position.
}
MAXI
P MAX 4 BAR
MINI
G0 00 213
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
3-28
©
200515
Inspection and adjustment
5
ΛΦ45/55 series
3.34 CHECK THE CLUTCH WEAR INDICATOR
1.
Check that the wear indicator on the clutch
servo has not gone past the mark on the
clutch servo plate.
2.
If the wear indicator is at the mark on the
clutch servo, replace the clutch plate.
3.35 CHECKING THE GEARBOX FOR LEAKS
1.
Visually check the gearbox for leaks.
V3 00 374
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст