DAF LF45, LF55 Series. Manual — part 74
©
200338
3-3
Threaded connections
TECHNICAL DATA
ΛΦ45/55 series
0
0
Overview of standard tightening torques for
DAF clamping flange bolts and nuts, strength
class 12.9/12
Overview of tightening torques, banjo bolts
Torque wrench
-
Have torque wrenches regularly inspected
and calibrated.
Re-use of fasteners (bolt/nut/threaded end)
1.
Clean the thread (take particular care to
remove locking compound residues) and the
clamping faces
2.
Check the thread for damage.
To do so, manually screw a new nut/bolt onto
the thread to be checked.
If the new nut/bolt cannot be fully hand-
screwed onto the entire thread of the
fastener to be checked, the fastener is not
allowed to be re-used.
3.
Apply one drop of engine oil to the upper turn
of the bolt (threaded end)/lower turn of the
nut and one drop to the clamping faces
(other lubricants are not allowed).
4.
If a locking compound has been specified, oil
should not be applied to the thread.
Thread
Tightening torque
in Nm
M12
178
≥ 14
M14
274
≥ 22
M16
425
≥ 35
M18
550
≥ 45
Thread
Tightening torque
in Nm
M6
8
≥ 0.8
M8
15
≥ 1.5
M10
30
≥ 3
M12
40
≥ 4
M14
50
≥ 5
M16
60
≥ 6
M18
70
≥ 7
TECHNICAL DATA
3-4
©
200338
Threaded connections
0
ΛΦ45/55 series
0
New bolts/nuts
New DAF bolts and DAF nuts, except bolts M4 to
M8 with inner-Torx, have already been lubricated.
If bolts have not yet been lubricated, a lubricant
should be applied.
1.
Apply one drop of engine oil to the first turn
of the bolt/lower screw thread of the nut and
one drop to the clamping faces (other
lubricants are not allowed).
2.
If a locking compound has been specified, oil
should not be applied to the thread.
©
200338
4-1
Paint treatment
TECHNICAL DATA
ΛΦ45/55 series
0
0
4. PAINT TREATMENT
4.1 OVERVIEW OF PLASTICS USED
1
3
3
2 2 1
2
1
1
G0 00 206
1
SMC polyester
2
Thermoplastic polymer parts (ASA or ABS)
3
Fibre-glass reinforced polyester
TECHNICAL DATA
4-2
©
200338
Paint treatment
0
ΛΦ45/55 series
0
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст