DAF CF65, CF75, CF85 Series . Manual — part 993
©
200423
3-29
Removal and installation
FRONT AXLE/LEADING REAR AXLE
ΧΦ65/75/85 series
7
6
10. Remove the inner bearing (3) from the
axle (4) using a puller.
Installation of idler arm
1.
Before installation, check the running
surface of the seal (1) and the bearing
surfaces of the bearings (3) and (5) on the
axle (4). If damaged, the support should be
replaced.
2.
If required, replace the bearings.
3.
Apply grease to the inner bearing (3) and fit
the bearing into the idler arm (2).
4.
Install the new lubricant seal (1) using a
plastic mallet.
S7 00 073
3 4
S7 00 074
4
S7 00 075
FRONT AXLE/LEADING REAR AXLE
3-30
©
200423
Removal and installation
6
ΧΦ65/75/85 series
7
5.
Fill space (A) between the lubricant seal (1)
and the bearing (3) fully with grease.
6.
Install the idler arm (2), fitted with the
lubricant seal (1) and the inner bearing (3),
on the bearing support (4). Tap the inner
bearing (3) on to the bearing support (4)
using an appropriate driving tool (see arrow).
S7 00 412
A
3
1
S7 00 076
©
200423
3-31
Removal and installation
FRONT AXLE/LEADING REAR AXLE
ΧΦ65/75/85 series
7
6
7.
Fill space (B) between the bearing (3) and
the bearing (5) fully with grease.
8.
Apply grease to the outer bearing (5) and fit
the bearing into the idler arm (2). Fit the
adjusting nut (6) with the tapered side
pointing to the bearing. Use a socket wrench
(A) for this, special tool (DAF no. 0694821).
Adjust the bearing play using the adjusting
nut (6). See 'Technical data'.
9.
Fit a new lock plate (7) and tap the lip into the
recess of the adjusting nut (6) (see the
arrow). If the lip is not positioned over the
recess of the adjusting nut (6), the circlip (7)
can be turned.
10. Fit the lock nut (8) with the tapered side
pointing to the circlip. To do this, use the
special tool (DAF no. 0694821).
Tighten the lock nut to the specified torque.
See 'Technical data'.
S7 00 413
B
5
3
A
S7 00 070
S7 00 077
FRONT AXLE/LEADING REAR AXLE
3-32
©
200423
Removal and installation
6
ΧΦ65/75/85 series
7
11. Secure the lock nut (8) by tapping the lip of
the oil seal (7) into a recess of the lock nut. If
the lip is not positioned over the recess of the
adjusting nut, the adjusting nut should be
tightened until a recess can be reached.
Never loosen the lock nut (8).
Note:
Do not put grease in the cover.
12. Fit the cover (9) using a plastic mallet.
13. Install the steering rods.
14. Refit the remaining components you have
removed.
S7 00 078
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст