DAF CF65, CF75, CF85 Series . Manual — part 460
©
200324
3-1
Inspection and adjustment
ENGINE BRAKE, PE ENGINE
CF65/75/85 series
4
7
3. INSPECTION AND ADJUSTMENT
3.1 INSPECTION AND ADJUSTMENT, EXHAUST BRAKE
Checking exhaust brake
1.
Use air pressure to check the exhaust brake
(4) for smooth operation.
This can be done by electrically activating
the exhaust brake valve (2) or by
pressurising the exhaust brake cylinder (1)
yourself.
Setting the exhaust brake
1.
Release the ball head of the butterfly valve
control lever.
2.
Open the butterfly valve fully (exhaust brake
inactive), indicated by the mark (1) on the
butterfly valve shaft.
3.
Set the length of the piston rod (2), making
sure that without air pressure a pre-load of 1
to 2 mm is present.
I400533
3
2
4
1
I400186
1
2
ENGINE BRAKE, PE ENGINE
3-2
©
200324
Inspection and adjustment
7
CF65/75/85 series
4
©
200324
4-1
Removal and installation
ENGINE BRAKE, PE ENGINE
CF65/75/85 series
4
7
4. REMOVAL AND INSTALLATION
4.1 REMOVAL AND INSTALLATION OF EXHAUST BRAKE
Removing the exhaust brake
1.
Disconnect the air supply connection from
the operating cylinder.
2.
Remove the heat shield from the exhaust
elbow.
3.
Remove the 6 attachment nuts holding the
exhaust elbow to the turbocharger.
4.
Remove the clamping strip with which the
exhaust elbow is attached to the exhaust.
5.
Remove the exhaust elbow including the
butterfly valve.
Installation, exhaust brake
1.
Check the butterfly valve for smooth
operation.
2.
Check the sealing faces of the exhaust
elbow and the exhaust pipe.
3.
Clean the turbocharger stud bolts and apply
heat-resistant grease to the threads.
4.
Fit the exhaust elbow and butterfly valve.
5.
Evenly tighten the attachment nuts to the
specified torque.
6.
Fit the clamping strip.
7.
Check the setting of the exhaust brake; see
"Inspection and adjustment".
ENGINE BRAKE, PE ENGINE
4-2
©
200324
Removal and installation
7
CF65/75/85 series
4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст