DAF CF65, CF75, CF85 Series . Manual — part 1039
©
200424
3-15
Removal and installation
SINGLE REAR AXLE 1354
ΧΦ65/75/85 series
8
5
3.
Remove the split pin (4), ring (3) and yoke
pin (2) and remove the yoke (6) from the axle
housing.
4.
Remove the floating blocks (7) from the yoke
(6).
5.
Turn the pneumatic cylinder (1) out of the
housing.
6.
Check the toothing of the selector sleeve (9)
and the right satellite-gear housing flange for
signs of damage and wear.
7.
Check whether the selector sleeve moves
smoothly over the axle shaft.
8.
Check whether the yoke (6) moves smoothly
over the axle (5).
9.
If the toothing of the satellite-gear housing
flange appears to be damaged, you must not
only replace this flange but also the entire
satellite-gear housing. You cannot replace
these two components separately.
10. If necessary, remove the engaging cylinder
and check the various parts for signs of
damage.
Installing the differential lock
1.
Turn the engaging cylinder (1) with lock nut
entirely into the axle housing.
1
5
2
7
8
A800021
6
9
3
4
A800028
SINGLE REAR AXLE 1354
3-16
©
200424
Removal and installation
5
ΧΦ65/75/85 series
8
2.
Fit the yoke (6) with yoke pin (2), ring (3) and
split pin (4) to the cylinder control rod.
3.
Install the yoke with axle into the differential
housing, making sure that the threaded hole
of the axle points outward (see arrow).
4.
Use a nylon or copper hammer to tap the
axle into the axle housing until the axle
journal is positioned flush with or slightly
lower than the mating surface of axle
housing and differential.
1
5
2
7
8
A800021
6
9
3
4
A800030
©
200424
3-17
Removal and installation
SINGLE REAR AXLE 1354
ΧΦ65/75/85 series
8
5
5.
Fit the floating blocks (7) into the yoke (6). Fit
the selector sleeve (9) with the spring clip (8)
into the yoke. Pull the spring clip (8)
downward on both sides, so that the
narrowest part of the semicircular holes is
positioned behind the edges of the floating
blocks.
6.
Install the right axle shaft and slide it into the
selector sleeve.
7.
Slacken the engaging cylinder until the
selector sleeve is positioned inside the edge
of the axle housing. Make sure that the axle
shaft end is flush with the top of the selector
sleeve toothing.
8.
Install the differential.
A800031
A800032
SINGLE REAR AXLE 1354
3-18
©
200424
Removal and installation
5
ΧΦ65/75/85 series
8
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст