DAF CF65, CF75, CF85 Series . Manual — part 1166
©
200423
4-5
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
4.4 REMOVAL AND INSTALLATION, ENGINE OIL FILTER
To prevent skin injury, avoid
unnecessary contact with the
drained engine oil.
Removing the engine oil filter
1.
Place a tray beneath the engine oil filter.
2.
Unscrew the cap (2) a few turns until the
engine oil starts to flow out of the filter.
3.
Remove cap (2) when the engine oil filter is
empty.
4.
Remove the filter element (3) from the filter
housing (1).
Installing the engine oil filter
1.
Replace the sealing ring in the cap (2).
2.
Lightly lubricate the sealing ring with engine
oil.
3.
Fit a new filter element (3) in the filter
housing (1).
4.
Fit the cap (2) and tighten to the specified
torque, see main group "Technical data".
}
4
1
3
2
5
M201049
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-6
©
200423
Removal and installation
5
ΧΦ75 series
4.5 REMOVAL AND INSTALLATION, CENTRIFUGAL FILTER ROTOR
To prevent skin injury, avoid
unnecessary contact with the
drained engine oil.
Removing the centrifugal filter rotor
1.
Clean the cap (3) and the area around it.
2.
Remove the central bolt (4) and cap (3).
3.
Remove the rotor (2) from the cap (3).
Installing the centrifugal filter rotor
1.
Clean the interior of the cap (3).
2.
Check the central bolt (4) for damage.
3.
Replace the sealing ring (5).
4.
Fit the rotor (2) in the cap (3).
5.
Lightly oil the sealing ring (5) with engine oil
and fit the cap (3).
6.
Tighten the central bolt (4) to the specified
tightening torque, see main group "Technical
data".
7.
Start the engine and check for leakage.
8.
Inspect the engine oil level.
}
4
3
2
5
1
M200526
©
200423
4-7
Removal and installation
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
ΧΦ75 series
5
4.6 REMOVAL AND INSTALLATION, FUEL FILTER ELEMENT
When removing the fuel filter, a
quantity of fuel will escape. Collect
the fuel to avoid the risk of fire.
Removing the fuel filter element
1.
Remove the cover together with the fuel filter
element from the filter housing.
Note:
The fuel filter element is a disposable filter,
and may not be cleaned and reused.
Dispose of the filter as chemical waste.
}
i 400444
EXPLANATORY NOTES ON THE MAINTENANCE ACTIVITIES
4-8
©
200423
Removal and installation
5
ΧΦ75 series
Fitting the fuel filter element
1.
Replace the cover O-ring.
2.
Fit the fuel filter element in the cover
3.
Fit the cover with fuel filter element. Tighten
the filter cover to the specified torque. See
"Technical data".
4.
Pump for approximately 1 minute using the
primer pump to partially fill the filter housing
with fuel.
5.
Start the engine and run it at idling speed for
a few minutes; this will allow any air in the
filter housing to escape.
6.
If the motor will not start up or runs very
erratically, the fuel system must be bled, see
"Draining and filling".
7.
Check the fuel system for leaks.
i 400445
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст