Honda Civic. Manual — part 975
5. Reconnect the 22P connector to the power window master switch. Turn the
ignition switch ON (II), and make these input tests at the connector.
If any test indicates a problem, find and correct the cause, then recheck the
system.
If all the input tests prove OK, the control unit must be faulty; replace the
power window master switch.
MASTER SWITCH INPUT TEST (RECONNECTED)
2
BRN
Connect the No. 3 and
the No. 1 terminals and
No. 2 and No. 12
terminals momentarily
with jumper wires
passenger's power
window motor
operation: The
window should go
down.
power window
switch
An open in the
wire
13
LT
BLU
Connect the No. 20 and
the No. 14 terminals
and No. 13 and No. 12
terminals momentarily
with jumper wires
Check front
passenger's power
window motor
operation: The
window should go
down.
Faulty right
rear power
window motor
Faulty right
rear power
window switch
An open in the
wire
14
RED
Connect the No. 20 and
the No. 13 terminals
and No. 14 and No. 12
terminals momentarily
with jumper wires
Check right rear
power window
motor operation:
The window should
go down.
21
PUR
Connect the No. 15 and
the No. 21 terminals
and No. 22 and No. 12
terminals momentarily
with jumper wires
Check left rear
power window
motor operation:
The window should
go down.
Faulty left rear
power window
motor
Faulty left rear
power window
switch
An open in the
wire
22
GRN
Connect the No. 15 and
the No. 22 terminals
and No. 21 and No. 12
terminals momentarily
with jumper wires
Check left rear
power window
motor operation:
The window should
go down.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Windows - Civic (All Except Hybrid)
Cavity Wire Test condition
Test: Desired result
Possible cause if
result is not
obtained
3
GRN
Ignition switch
ON (II)
Check for voltage to
ground: There should be
battery voltage.
Blown No. 30
(20 A) fuse in
the under-
dash
fuse/relay box
Faulty power
window relay
Faulty MICU
An open in
the wire
4
WHT
Under all
conditions
Check for voltage to
ground: There should be
battery voltage.
Blown No. 26
(20 A) fuse in
the under-
hood
fuse/relay box
An open in
the wire
15
[20]
RED
Ignition switch
ON (II)
Check for voltage to
ground: There should be
battery voltage.
Blown No. 32
(20 A) fuse in
the under-
dash
fuse/relay box
Faulty power
window relay
Faulty MICU
An open in
the wire
Blown No. 33
(20 A) fuse in
the under-
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Windows - Civic (All Except Hybrid)
20
[15]
PUR
Ignition switch
ON (II)
Check for voltage to
ground: There should be
battery voltage.
dash
fuse/relay box
Faulty power
window relay
Faulty MICU
An open in
the wire
7
BRN
Under all
conditions
Check for voltage to
ground: There should be
less than 0.5 V.
Poor ground
(G503)
An open in
the wire
11
BLK
Ignition switch
ON (II), and
driver's window
moving up and
down
Check for voltage to
ground: There should be
less than 0.5 V.
Poor ground
(G503)
An open in
the wire
12
BLK
Ignition switch
ON (II), main
switch ON, and a
passenger's
window moving
up and down
Check for voltage to
ground: There should be
less than 0.5 V.
Poor ground
(G503)
An open in
the wire
16
PUR
Ignition switch
ON (II)
Check for voltage to
ground: There should be
battery voltage.
Faulty power
window
master switch
Short to
ground in the
wire
5
PNK
Ignition switch
ON (II), and
driver's power
window switch
Check for voltage between
the No. 5 and No. 7
terminals: There should be
0 V-about 5 V -0 V-about
5 V repeatedly (a digital
Faulty power
window
master switch
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Windows - Civic (All Except Hybrid)
6. Reset the power window control unit (see RESETTING THE POWER
WINDOW CONTROL UNIT ).
2-DOOR WITH AUTO UP/AUTO DOWN FUNCTION
1. Remove the door panel (see DOOR PANEL
REMOVAL/INSTALLATION ).
2. Disconnect the 16P connector (A) from the master switch (B).
moving up or
down
voltmeter should reads
about 2.5 V while the
window moves).
Faulty driver's
power
window
motor
An open in
the wire
Short to
ground in the
wire
6
ORN
Ignition switch
ON (II), and
driver's power
window switch
moving up or
down
Check for voltage between
the No. 6 and No. 7
terminals: There should be
0 V-about 5 V -0 V- about
5 V repeatedly (a digital
voltmeter should reads
about 2.5 V while the
window moves).
[ ] : early production
NOTE:
The power window control unit is built into the power
window master switch, and it only controls the driver's
window operations.
2008 Honda Civic EX
2006-08 ACCESSORIES & EQUIPMENT Power Windows - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст