Honda Civic. Manual — part 436
Fig. 19: Clamping Driveshaft In Bench Vise
Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the outboard joint (A) using the threaded adapter (B) and a
commercially available 5/8"-18 UNF slide hammer (C).
7. Remove the driveshaft from the bench vise.
8. Remove the stop ring from the driveshaft.
Fig. 20: Identifying Stop Ring
Courtesy of AMERICAN HONDA MOTOR CO., INC.
9. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging to
the boot.
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
Fig. 21: Identifying Driveshaft Vinyl Tape
Courtesy of AMERICAN HONDA MOTOR CO., INC.
10. Remove the outboard boot. Be careful not to damage the boot.
11. Remove the vinyl tape.
DYNAMIC DAMPER REPLACEMENT
1. Remove the inboard joint (see INBOARD JOINT SIDE ).
2. Remove the double loop band or low profile bands (see step 2 ).
If the band is a welded type, cut the band.
If the band is a double loop type, lift up the band bend, and push it into the
clip.
If the band is a low profile type, pinch the band using a commercially
available boot band pliers.
3. Remove the dynamic damper. Type A
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
Fig. 22: Identifying Dynamic Damper
Courtesy of AMERICAN HONDA MOTOR CO., INC.
DYNAMIC DAMPER TYPE
Model
Factory
Type
5-speed M/T Model (Except Si)
Suzuka Factory
Right Type A
Left Type A
Except Suzuka Factory
Right Type A
Left Type A
6-speed M/T Model (Si)
Right Type B
Left Type B
Right Type A
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
4. Install the new dynamic damper and adjust the position of the new dynamic
damper to these measurements
A/T Model
Suzuka Factory
Left Type C
Except Suzuka Factory
Right Type A
Left Type C
NOTE:
Be careful not to swap the dynamic damper.
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст