Honda Civic. Manual — part 434
Fig. 4: Identifying Driveshaft Spindle Nut
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Drain the transmission fluid. Reinstall the drain plug with a new washer:
5-speed Manual transmission (except Si) (see TRANSMISSION FLUID
INSPECTION AND REPLACEMENT )
6-speed Manual transmission (Si) (see TRANSMISSION FLUID
INSPECTION AND REPLACEMENT ).
Automatic transmission (see ATF REPLACEMENT )
5. Remove the nuts and bolt, then separate the lower arm with a prybar.
Fig. 5: Identifying Lower Arm Nuts And Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the driveshaft outboard joint from the front wheel hub using a plastic
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
hammer.
Fig. 6: Taping Driveshaft Outboard Joint
Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Pull the knuckle outward, and remove the driveshaft outboard joint from the
front wheel hub.
Fig. 7: Identifying Driveshaft Outboard Joint
Courtesy of AMERICAN HONDA MOTOR CO., INC.
8. Right driveshaft: Drive the inboard joint (A) off of the intermediate shaft using
a drift and hammer (M/T model). Pry the inboard joint (B) from the
transmission housing with a prybar (A/T model). Remove the driveshaft as an
assembly.
NOTE:
Do not pull on the driveshaft (C) or the inboard joint
may come apart. Pull the driveshaft straight out to
avoid damaging the oil seal.
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
M/T model:
Fig. 8: Taping Inboard Joint - M/T Model
Courtesy of AMERICAN HONDA MOTOR CO., INC.
A/T model:
Fig. 9: Prying Inboard Joint - A/T Model
Courtesy of AMERICAN HONDA MOTOR CO., INC.
9. Left driveshaft: Pry the inboard joint (A) from the transmission housing with a
prybar. Remove the driveshaft as an assembly.
NOTE:
Do not pull on the driveshaft (B) or the inboard joint
may come apart. Pull the driveshaft straight out to
avoid damaging the oil seal.
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
Fig. 10: Pulling Driveshaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
DRIVESHAFT DISASSEMBLY
Special Tools Required
Threaded adapter, 22 x 1.5 mm 07XAC-001010A
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
Slide hammer, 5/8"-18 UNF, commercially available
INBOARD JOINT SIDE
1. Remove the set ring (A) from the inboard joint.
Fig. 11: Identifying Set Ring
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the boot bands. Be careful not to damage the boot.
If the boot band is a welded type (A), cut the boot band.
2008 Honda Civic GX
2006-08 DRIVELINE/AXLES Driveline/Axle - Civic (All Except Hybrid)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст