Honda Ridgeline. Manual — part 588
01
SJC8A00H46400055408KBAT00
Removal
Left side shown; right side is similar
24-177
Side Curtain Airbag Replacement
A
NOTE:
• Removal of the side curtain airbag must be done according to Precaution and Procedures (see page 24-17).
• The side curtain airbag system consists of the side curtain airbag module, including the roof trim, front grab handle,
all grab handle brackets, and shielding protector. When the side curtain airbag has been deployed, these parts
should be replaced (see page 24-171).
1. Disconnect the negative cable from the battery, then wait 3 minutes before starting work.
2. Remove the headliner (see page 20-70).
3. Disconnect the side curtain airbag 2P connector (A) from the roof wire harness.
(cont’d)
02
Left side shown; right side is similar
24-178
SRS
Side Curtain Airbag Replacement (cont’d)
A
A
A
A
A
A
4. Remove the mounting bolts (A) from the bracket.
03
Installation
Left side shown; right side is similar
24-179
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
A
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
NOTE:
• Installation of the side curtain airbag must be done according to Precaution and Procedures (see page 24-17).
• If the airbag is frayed, or has only other visible damage, replace it. Do not attempt to repair an airbag.
• When you install the airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the
bracket bolts.
• Make sure that the side curtain airbag inflator retainer is installed properly, otherwise the airbag could incorrectly
deploy and cause damage or injuries.
• Check if the clips are damaged or stress-whitened, and if nessessary, replace them with new ones.
1. Place the new side curtain airbag assembly on the side of the roof. Tighten the side curtain airbag mounting bolts
(A).
(cont’d)
04
Left side shown; right side is similar
24-180
SRS
Side Curtain Airbag Replacement (cont’d)
A
2. Connect the side curtain airbag 2P connector (A) to the roof wire harness.
3. Reconnect the negative cable to the battery.
4. Connect the HDS, and clear the DTCs (see page 24-28).
5. After installing the side curtain airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS
indicator should come on for about 6 seconds and then go off.
6. Install all removed parts.
7. Confirm proper headliner/pillar trim overlap (see page 24-173).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст