Honda Element. Manual — part 636
1. Remove the ball bearing (A) from the clutch housing (B) using the 20-40 mm adjustable bearing puller
(C) and a commercially available 3/8 "-16 UNF slide hammer (D).
Fig. 126: Removing Ball Bearing Of Clutch Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the 28 x 43 x 7 mm oil seal (A) from the transmission side. Be careful when removing the seal so
the clutch housing is not damaged.
Fig. 127: Removing Oil Seal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Drive in the new 28 x 43 x 7 mm oil seal from the transmission side using the 42 x 47 mm attachment (A)
and driver (B).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Fig. 128: Installing Oil Seal
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Drive in the new ball bearing (A) from the transmission side using the oil seal driver (B).
Fig. 129: Installing Ball Bearing Of Transmission Side
Courtesy of AMERICAN HONDA MOTOR CO., INC.
COUNTERSHAFT BEARING REPLACEMENT
Special Tools Required
Oil seal driver 07JAD-PL90100
Adjustable bearing puller, 20-40 mm 07736-A01000B
Slide hammer, 3/8 "-16 UNF commercially available
1. Remove the bearing set plate (A) from the clutch housing (B).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Fig. 130: Identifying Bearing Set Plate And Clutch Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the needle bearing (A) using the 20-40 mm adjustable bearing puller (B) and a commercially
available 3/8 "-16 UNF slide hammer (C), then remove the oil guide plate C (D).
Fig. 131: Removing Needle Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Position the oil guide plate C (A) and new needle bearing (B) in the bore of the clutch housing (C).
Fig. 132: Positioning Oil Guide Plate, Needle Bearing And Clutch Housing
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the needle bearing using the oil seal driver (D).
5. Install the bearing set plate (A) with bolts (B).
Fig. 133: Identifying Bearing Set Plate With Bolts With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
MAINSHAFT THRUST CLEARANCE ADJUSTMENT
Special Tools Required
Mainshaft holder 07GAJ-PG20110
Mainshaft base 07GAJ-PG20130
1. Remove the 72 mm shim (A) and oil guide plate M from the transmission housing (B).
Fig. 134: Identifying Shim, Oil Guide Plate M And Transmission Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Thoroughly clean the 28 mm spring washer (A) and 28 mm washer (B) before installing them on the
clutch housing side bail bearing (C).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст