Honda Odyssey 2004. Manual — part 37
27
28
29
5-10
Engine Assembly
Engine Removal (cont’d)
48. Attach the chain hoist to the engine as shown.
49. Remove the side engine mount bracket.
50. Remove the front mount bracket support nut.
03/07/29 09:09:16 61S0X050_050_0010
30
31
32
*05
5-11
51. Raise the hoist to full height.
52. Draw alignment marks on the front subframe.
53. Remove the front subframe.
54. Hang the steering gearbox with a rope to the frame.
55. Remove the A/C compressor without disconnecting
the A/C hoses.
56. Check that the engine/transmission is completely
free of vacuum hoses, fuel and coolant hoses, and
electrical wiring.
57. Slowly lower the engine about 150 mm (6 in.).
Check once again that all hoses and wires are
disconnected from the engine/transmission.
58. Lower the engine/transmission assembly all the
way. Remove the chain hoist from the engine.
59. Remove the engine/transmission assembly from
under the vehicle.
03/07/29 09:09:17 61S0X050_050_0011
01
S0X4A00A18223800000KCAT00
5-12
Engine Assembly
Engine Installation
ENGINE MOUNT
BRACKET
10 x 1.25 mm
44 N·m (4.5 kgf·m,
33 lbf·ft)
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
8 x 1.25 mm
22 N·m
(2.2 kgf·m, 16 lbf·ft)
P/S PUMP
BRACKET
FRONT MOUNT
BRACKET
10 x 1.25 mm
38 N·m (3.9 kgf·m,
28 lbf·ft)
A/C COMPRESSOR
BRACKET
10 x 1.25 mm
44 N·m (4.5 kgf·m,
33 lbf·ft)
10 x 1.25 mm
38 N·m
(3.9 kgf·m, 28 lbf·ft)
REAR MOUNT
BRACKET
1. Install the accessory brackets. Tighten their bolts and nuts to the specified torques.
03/07/29 09:09:18 61S0X050_050_0012
*01
03
04
5-13
8 x 1.25 mm
22 N·m (2.2 kgf·m, 16 lbf·ft)
12 x 1.25 mm
74 N·m
(7.5 kgf·m,
54 lbf·ft)
14 x 1.5 mm
103 N·m (10.5 kgf·m,
76 lbf·ft)
12 x 1.25 mm
117 N·m
(11.9 kgf·m,
86 lbf·ft)
2. Position the engine/transmission assembly under
the vehicle. Attach the chain hoist to the engine,
then lift the engine into position in the vehicle.
Reinstall the mounting bolts/nuts in the
sequence given. Failure to follow this
sequence may cause excessive noise and
vibration, and reduce bushing life.
3. Install the A/C compressor.
4. Install the front subframe. Align the reference
marks on the front subframe, then tighten the bolts.
(cont’d)
Replace.
03/07/29 09:09:19 61S0X050_050_0013
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст