Honda Odyssey 2004. Manual — part 560
−
−
−
−
−
−
01
02
*01
03
YES
NO
YES
NO
YES
NO
23-182
SRS
DTC Troubleshooting (cont’d)
SRS UNIT CONNECTOR B (18P)
SRS UNIT CONNECTOR B (18P)
C852
A
SRS FLOOR SUBHARNESS 28P CONNECTOR
7. Check resistance between the No. 8 terminal of
SRS unit connector B (18P) and body ground. There
should be an open circuit, or at least 1 M
.
Go to step 8.
Go to step 9.
8. Check resistance between the No. 8 and No. 15
terminals of SRS unit connector B (18P). There
should be an open circuit, or at least 1 M
.
Faulty driver’s side impact sensor or SRS
unit; replace the driver’s side impact sensor (see
page 23-385). If the problem is still present, replace
the SRS unit (see page 23-382).
Go to step 11.
9. Disconnect the SRS floor subharness 28P
connector (A) from the SRS floor harness 28P
connector C852.
10. Check resistance between the No. 18 terminal of
the SRS floor subharness 28P connector and body
ground. There should be an open circuit, or at least
1 M
.
Short to ground in the SRS floor harness;
replace the SRS floor harness.
Short to ground in the SRS floor subharness
or left side wire harness; replace the faulty
harness.
Wire side of female terminals
Wire side of female terminals
Wire side of female terminals
Is the r esistance as specif ied?
Is the r esistance as specif ied?
Is the r esistance as specif ied?
03/07/29 10:36:26 61S0X050_230_0182
−
−
*02
04
YES
NO
23-183
C852
A
SRS FLOOR SUBHARNESS 28P CONNECTOR
11. Disconnect the SRS floor subharness 28P
connector (A) from the SRS floor harness 28P
connector C852.
12. Check resistance between the No. 18 and No. 17
terminals of the SRS floor subharness 28P
connector. There should be an open circuit, or at
least 1 M
.
Short in the SRS floor harness; replace the
SRS floor harness.
Short in the SRS floor subharness or left side
wire harness; replace the faulty harness.
Wire side of female terminals
Is the r esistance as specif ied?
03/07/29 10:36:26 61S0X050_230_0183
−
−
−
−
01
*02
S0X4AC5K79100081143FAAT00
’02 Model
DTC 14-3:
Special Tools Required
YES
NO
YES
NO
23-184
SRS
DTC Troubleshooting (cont’d)
A
A
07YAZ-S3AA100
07SAZ-TB4011A
B
A
No Signal from the Front
Passenger’s Side Impact Sensor
• SRS inflator simulator 07SAZ-TB4011A
• SRS simulator lead H 07YAZ-S3AA100
1. Erase the DTC memory (see page 23-38).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Go to step 3.
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Check the connection between the right side wire
harness 2P connector and the front passenger’s
side impact sensor.
Go to step 5.
Poor contact between the right side wire
harness 2P connector and the front passenger’s
side impact sensor; replace the front passenger’s
side impact sensor (see page 23-385).
5. Disconnect the driver’s side airbag and front
passenger’s side airbag 2P connectors (A).
6. Disconnect the right side wire harness 2P
connector (A) from the front passenger’s side
impact sensor (B).
7. Connect the special tool (jumper connector) to the
right side wire harness 2P connector.
Does the SRS indicator stay on?
Is the connection OK ?
03/07/29 10:36:27 61S0X050_230_0184
−
−
−
−
−
−
03
01
*01
02
YES
NO
YES
NO
23-185
B
SRS UNIT CONNECTOR B (18P)
C852
A
SRS FLOOR SUBHARNESS 28P CONNECTOR
8. Disconnect SRS unit connector B (18P) from the
SRS unit.
9. Check resistance between the No. 9 and No. 16
terminals of SRS unit connector B (18P). There
should be 0
1.0
.
Faulty front passenger’s side impact sensor
or SRS unit; replace the front passenger’s side
impact sensor (see page 23-385). If the problem is
still present, replace the SRS unit
(see page 23-382).
Go to step 10.
10. Disconnect the SRS floor subharness 28P
connector (A) from the SRS floor harness 28P
connector C852.
11. Check resistance between the No. 28 and No. 27
terminals of the SRS floor subharness 28P
connector. There should be 0
1.0
.
Open in the SRS floor harness; replace the
SRS floor harness.
Open in the SRS floor subharness or right
side wire harness; replace the faulty harness.
Wire side of female terminals
Wire side of female terminals
Is the r esistance as specif ied?
Is the r esistance as specif ied?
03/07/29 10:36:28 61S0X050_230_0185
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст