Honda Odyssey 2004. Manual — part 497
*03
04
Door Side (’01-04 EX and ’02-04 EXL models)
22-316
Power Sliding Doors
Sliding Door Junction Switch Test (cont’d)
YEL/
RED
BLK
WHT/
RED
Right:
Left:
BLU/
BLK
LT GRN/
RED
BLK
GRN/BLK
GRN/RED
BLK
YEL/GRN
BLU/YEL
WHT/RED
BLU/RED
BLK
BLU/WHT
GRY
Left:
YEL/RED
BLK
RED/BLU
WHT/RED
Right:
A
B
C
D
E
F
G
H
I
J
F
D
C
B
A
K
J
I
H
G
BLU/
RED
BLU/
WHT
E
K
RED/
WHT
A
A
B
C
D
E
F
G
B1 B3 B4
H
I
J
K A3, A5, A6, D1, A4 A8
B6
D3
C2
D5
C3 C4
E2 D2, B5, E3
E1 C1,
D6,
E4
1. Remove the sliding door panel (see page 20-13).
2. Disconnect the connectors from the switch (A).
3. Check for continuity between the terminals
according to the tables.
4. If the continuity is not as specified, replace the
switch.
Wire side of female terminals
Terminal side of
male terminals
Wire side of
female terminals
03/07/29 10:27:22 61S0X050_220_0318
01
02
S0X4A00J16160755655FEAT00
22-317
Sliding Door Handle Switch Test
BLK
BLU
Terminal
Position
A
B
1
2
B
A
1. Disconnect the 2P connector from the sliding door
handle switch (A).
2. Remove the two mounting screws from the switch.
3. Check for continuity between the terminals in each
switch position according to the table.
4. If the continuity is not as specified, replace the
switch.
Wire side of famale terminals
03/07/29 10:27:23 61S0X050_220_0319
01
02
01
02
S0X4A00J16160755631FEAT00
22-318
Power Sliding Doors
Left Slide Motor Revolution Sensor Test
1. Remove the rear side trim panel (see page 20-60).
2. Check for voltage between the No. 4 terminal and
body ground. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the RED wire.
– a short in the wire.
3. Check for voltage between the No. 4 and No. 1
terminals. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the PNK/BLK wire.
4. Turn the power sliding door main switch OFF.
5. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A26 and A24.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty left slide motor revolution sensor.
– an open or a short in the LT GRN/BLK wire.
6. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A12 and A24.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty left slide motor revolution sensor.
– an open or a short in the RED/BLK wire.
Wire side of
female terminals
Wire side of
female terminals
Wire side of female terminals
Wire side of female terminals
03/07/29 10:27:24 61S0X050_220_0320
01
02
01
02
S0X4A00J16160755632FEAT00
22-319
Right Slide Motor Revolution Sensor Test
1. Remove the rear side trim panel (see page 20-60).
2. Check for voltage between the No. 4 terminal and
body ground. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the RED wire.
– a short in the wire.
3. Check for voltage between the No. 4 and No. 1
terminals. There should be battery voltage.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– an open in the PNK/BLK wire.
4. Turn the power sliding door main switch OFF.
5. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A17 and A2.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty right slide motor revolution sensor.
– an open or a short in the RED/BLK wire.
6. While slowly sliding the door manually, check for
voltage between the power sliding door control
unit terminals A2 and A15.
There should be 0 to about 5 V repeatedly.
• If there is no voltage, check the following:
– a faulty power sliding door control unit.
– a faulty right slide motor revolution sensor.
– an open or a short in the LT GRN/BLK wire.
Wire side of
female terminals
Wire side of
female terminals
Wire side of female terminals
Wire side of female terminals
03/07/29 10:27:24 61S0X050_220_0321
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст