Honda Odyssey 2004. Manual — part 519
01
S0X4AZ4H46400000000DAAT00
[
]
’99-01 Models
23-18
SRS
Component Location Index
SRS INDICATOR
CABLE REEL
To HORN SWITCH
To CRUISE CONTROL
SET/RESUME SWITCH
To DRIVER’S AIRBAG
FRONT PASSENGER’S AIRBAG
MEMORY ERASE SIGNAL
(MES) CONNECTOR (2P)
GRN, GRN
SRS MAIN HARNESS
to SRS UNIT
18P CONNECTOR
SRS UNIT
GROUND
SRS UNIT
DATA LINK
CONNECTOR
(DLC) (16P)
SRS MAIN HARNESS
to DRIVER’S UNDER-DASH
FUSE/RELAY BOX
2P CONNECTOR
To RADIO REMOTE
SWITCH
DRIVER’S SEAT BELT TENSIONER
FRONT PASSENGER’S SEAT
BELT TENSIONER
DRIVER’S AIRBAG
Troubleshooting, page 23-337
Replacement, page 23-376
Replacement, page 23-370
Disposal, page 23-373
Replacement, page 23-382
Replacement, page 23-4
Disposal, page 23-373
Replacement, page 23-4
Disposal, page 23-373
Replacement, page 23-368
Disposal, page 23-373
03/07/29 10:30:46 61S0X050_230_0018
*01
S0X4AZ3H46400000000DAAT00
’02 Model
23-19
OPDS SENSOR/
SEAT BACK
OPDS UNIT
MEMORY ERASE
SIGNAL (MES)
CONNECTOR (2P)
DATA LINK
CONNECTOR
(DLC) 16P
FRONT PASSENGER’S AIRBAG
DRIVER’S SIDE AIRBAG
DRIVER’S AIRBAG
SRS UNIT
DRIVER’S SIDE IMPACT SENSOR
SIDE AIRBAG
CUTOFF INDICATOR
SRS INDICATOR
FRONT PASSENGER’S SEAT
BELT TENSIONER
DRIVER’S SEAT BELT TENSIONER
FRONT PASSENGER’S SIDE
IMPACT SENSOR
CABLE REEL
LEFT FRONT IMPACT SENSOR
RIGHT FRONT
IMPACT SENSOR
FRONT PASSENGER’S
SIDE AIRBAG
Replacement,
page 20-102
Initialization, page 23-40
Replacement, page 23-387
Replacement, page 23-370
Disposal, page 23-373
Replacement, page 23-372
Disposal, page 23-373
Replacement, page 23-368
Disposal, page 23-373
Replacement,
page 23-382
Replacement, page 23-385
Troubleshooting, page 23-349
Replacement, page 23-4
Disposal, page 23-373
Replacement, page 23-4
Disposal, page 23-373
Replacement, page 23-385
Replacement, page 23-377
Replacement, page 23-388
Replacement,
page 23-388
Replacement,
page 23-372
Disposal,
page 23-373
03/07/29 10:30:51 61S0X050_230_0019
*01
S0X4ASIH46400000000DAAT00
’03-04 Models
23-20
SRS
Component Location Index (cont’d)
OPDS SENSOR/
SEAT BACK
OPDS UNIT
MEMORY ERASE
SIGNAL (MES)
CONNECTOR (2P)
DATA LINK
CONNECTOR
(DLC) 16P
FRONT PASSENGER’S AIRBAG
DRIVER’S SIDE AIRBAG
DRIVER’S AIRBAG
SRS UNIT
SRS INDICATOR
FRONT
PASSENGER’S
SEAT BELT
TENSIONER
DRIVER’S SEAT BELT TENSIONER
FRONT PASSENGER’S SIDE
IMPACT SENSOR
CABLE REEL
LEFT FRONT IMPACT SENSOR
RIGHT FRONT
IMPACT SENSOR
DRIVER’S SIDE IMPACT SENSOR
FRONT PASSENGER’S
WEIGHT SENSORS
FRONT PASSENGER’S
WEIGHT SENSORS UNIT
PASSENGER’S AIRBAG CUTOFF INDICATOR
FRONT PASSENGER’S
SIDE AIRBAG
DRIVER’S SEAT POSITION SENSOR
SIDE AIRBAG
CUTOFF INDICATOR
Replacement,
page 20-102
Initialization, page 23-41
Replacement, page 23-387
Replacement, page 23-370
Disposal, page 23-373
Replacement, page 23-372
Disposal, page 23-373
Replacement, page 23-368
Disposal, page 23-373
Replacement,
page 23-384
Troubleshooting, page 23-361
Replacement,
page 23-4
Disposal,
page 23-373
Replacement, page 23-4
Disposal, page 23-373
Replacement, page 23-386
Replacement, page 23-377
Replacement,
page 23-389
Replacement,
page 23-389
Replacement, page 23-386
Replacement, page 23-390
Replacement, page 23-391
Calibration, page 23-42
Bulb test, page 23-393
Troubleshooting, page 23-326
Replacement,
page 23-372
Disposal,
page 23-373
Replacement, page 23-392
Operation check, page 23-47
03/07/29 10:30:57 61S0X050_230_0020
*01
S0X4A00H46400000000AAAT00
General Precautions
Steering-related Precautions
Cable Reel Alignment
23-21
Precautions and Procedures
Please read the following precautions carefully before
performing airbag system service. Observe the
instructions described in this manual, or the airbags
could accidentally deploy and cause damage or injuries.
• Except when performing electrical inspections,
always turn the ignition switch OFF disconnect the
negative cable from the battery, and wait at least 3
minutes before beginning work.
NOTE: The memory is not erased even if the ignition
switch is turned OFF or the battery cables are
disconnected from the battery.
• Use replacement parts which are manufactured to the
same standards and quality as the original parts. Do
not install used SRS parts. Use only new parts when
making SRS repairs.
• Carefully inspect any SRS part before you install it.
Do not install any part that shows signs of being
dropped or improperly handled, such as dents, cracks
or deformation.
• Before removing any SRS parts (including
disconnection of connectors), always disconnect the
SRS connector.
• Use only a digital multimeter to check the system. If it
is not a Honda multimeter, make sure its output is 10
mA (0.01A) or less when switched to the lowest value
in the ohmmeter range. A tester with a higher output
could cause accidental deployment and possible
injury.
• Do not put objects on the front passenger’s airbag.
• The original radio has a coded theft protection circuit.
Be sure to get the customer’s radio and navigation
system codes and write down the frequencies for the
radio’s preset stations before disconnecting the
battery cable.
• Before returning the vehicle to the customer, enter
the radio and navigation system codes, then enter the
customer’s radio station presets, and set the clock.
Do the powertrain control module (PCM) idle learn
procedure (see page 11-202).
• After disconnecting the battery negative cable, do the
power window control unit resetting procedure (see
page 22-200).
• Misalignment of the cable reel could cause an open in
the wiring, making the SRS system and the horn
inoperative. Center the cable reel whenever the
following is performed (see step 6 on page 23-379).
– Installation of the steering wheel
– Installation of the cable reel
– Installation of the steering column
– Other steering-related adjustment or installation
• Do not disassemble the cable reel.
• Do not apply grease to the cable reel.
• If the cable reel shows any signs of damage, replace
it with a new one. For example, it does not rotate
smoothly.
(cont’d)
03/07/29 10:30:58 61S0X050_230_0021
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст