Mitsubishi Colt Ralliart. Manual — part 285
AK102789
TRANSMISSION
CONTINUOUSLY VARIABLE TRANSMISSION OVERHAUL
23B-13
7. Remove the turbine speed sensor from the
transmission case.
AK102788
8. Remove the primary speed sensor from the
transmission case.
AK102787
9. Remove the primary pressure sensor from the
primary rear cover.
AK102786
10.Remove the secondary pressure sensor from the
secondary rear cover.
AK401958
11.Remove the manual control lever from the manual
control shaft.
AK401959
12.Remove the inhibitor switch from the transmission
case.
AK102783
13.Remove the secondary rear cover from the
transmission case.
AK103576
14.Remove the seal ring from the secondary rear
cover.
Main
Index
Group
TOC
AK102779
TRANSMISSION
CONTINUOUSLY VARIABLE TRANSMISSION OVERHAUL
23B-14
15.Remove the O-ring and stopper from the
transmission case.
AK102778
16.Remove the primary rear cover from the
transmission case.
AK103575
17.Remove the seal ring from the primary rear cover.
AK102776
18.Remove the O-rings (three pieces) from the
transmission case.
AK401960
19.Remove the valve body cover from the
transmission case.
AK102773
20.Remove the clamp that holds the connector of
solenoid valve harness.
AK401961AC
CAUTION
Do not remove the bolts (two pieces) shown in
the illustration.
21.Remove the valve body mounting bolts (thirty four
bolts other than the two shown in the illustration),
then remove the valve body from the transmission
case.
Main
Index
Group
TOC
AK102823
TRANSMISSION
CONTINUOUSLY VARIABLE TRANSMISSION OVERHAUL
23B-15
22.Remove the steel ball indicated in the illustration
from the valve body.
AK401962
CAUTION
The spacer (for adjusting the differential bearing
clearance), O-rings (five pieces), and accumula-
tor springs (two pieces) may come off together
with the converter housing.
23.Remove the converter housing from the
transmission case.
AK401963AD
24.Remove the O-rings (five pieces) and the spacer
for adjusting the differential bearing clearance
(see the illustration).
NOTE: The O-ring and spacer may attach to the
converter housing which was removed in the pre-
ceding step.
AK102760
25.Remove the accumulator springs (two pieces)
from the reaction shaft support.
AK401967
26.Remove the oil pipe from the converter housing.
AK401970
27.Remove the snap ring and stopper plate on the
reaction shaft support.
AK102759
28.Remove the accumulator piston from the reaction
shaft support.
Main
Index
Group
TOC
AK401971
TRANSMISSION
CONTINUOUSLY VARIABLE TRANSMISSION OVERHAUL
23B-16
29.Remove the oil filter from the transmission case.
AK102756
30.Remove the chain and oil pump drive sprocket.
AK401975
31.Remove the output shaft and differential from the
transmission case.
AK401978
32.Remove the thrust bearing from the bearing
retainer.
AK401976
33.Remove the output shaft bearing outer race and
bearing retainer from the transmission case.
AK102754
34.Remove the oil pump driven sprocket from the oil
pump by opening the snap ring shown in the
illustration.
AK102753
35.Detach the snap ring that retains the oil pump
driven sprocket from the oil pump.
AK402304AC
36.Remove the bolts (four pieces) shown in the
illustration, then remove the oil pump from the
transmission case.
Main
Index
Group
TOC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст