Mitsubishi 380. Manual — part 971
TRANSMISSION ASSEMBLY
MANUAL TRANSMISSION
22A-9
<<B>> CLUTCH RELEASE CYLINDER
09DB030A
18 ± 3.0 N·m
18 ± 3.0 N·m
1. Remove the clutch release cylinder without disconnecting
the fluid line and secure to vehicle chassis.
.
<<C>> RELEASE BEARING
09DB025A
1. Remove the access hole covers from th top and bottom of
the clutch housing.
2. Push the clutch cylinder end of the release fork so that the
release bearing pushes against the diaphram spring.
09DB026A
09DB027A
DIAPHRAGM SPRING
RELEASE
BEARING
RING
Place
screwdriver
here
3. Insert a flat blade screwdriver in both top and bottom access
hole in the clutch housing, between the release bearing and
the diaphram spring. Simultaneously turn both srewdrivers
through 90 to diengage the release bearing.
.
TRANSMISSION ASSEMBLY
MANUAL TRANSMISSION
22A-10
<<D>> TRANSMISSION MOUNT BRACKET
09DB035A
CHASSIS BRACKET
MOUNT
1. Jack up the transmission assembly gently with garage jack
and then remove the transmission mount bracket through
bolt. Mount assembly remains attached to transmission until
removed from vehicle.
.
<<E>> ENGINE ASSEMBLY SUPPORTING
AC306198
MB991527
MB991454
MB991895
AB
1. Set up the special tool to the vehicle to support the engine
assembly.
.
<<F>> TIE ROD END/LOWER ARM BALL JOINT REMOVAL
AC208247AC
CORD
BOLT
MB991897
NUT
BALL JOINT
1. Set up the special tool to the vehicle to support the engine
assembly.
.
<<G>> DRIVE SHAFT REMOVAL
AC100141AL
TRANSAXLE
PTJ ASSEMBLY
PRY BAR
1. Insert a pry bar between the transmission case and the drive
shaft to remove the shaft from trnsmission housing.
09DB028A
MB991460
TRANSMISSION ASSEMBLY
MANUAL TRANSMISSION
22A-11
2. To prevent foreign material from entering the transmission
case, insert a suitable plug into the drive shaft openings.
3. Suspend the RH drive shaft with wire so that there are no
sharp bends in any of the joints.
INSTALLATION SERVICE POINT
.
>>A<< TRANSMISSION MOUNT STOPPER INSTALLATION
09DB029A
ENGINE SIDE
TRANSAXLE
MOUNTING
STOPPER
1. Install the transmission mount stopper so that the arrow
points upward as shown in illustration. Ensure stoppers are
installed onto mount correctly prior to fitment and do not
dislodge during transmission installation.
TRANSMISSION ASSEMBLY
MANUAL TRANSMISSION
22A-12
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст