Mitsubishi Grandis. Manual — part 961
STEERING WHEEL SENSOR
TRACTION CONTROL/ACTIVE STABILITY CONTROL SYSTEM
35C-169
INSTALLATION SERVICE POINT
>>A<< STEERING WHEEL SENSOR
NEUTRAL POINT ALIGNMENT
WARNING
Ensure that the clock spring’s mating marks
are properly aligned. If not, the steering
wheel may not rotate completely during a
turn, or the flat cable in the clock spring
could be damaged, This would prevent
normal SRS operation and possibly cause
serious injury to the driver.
1. Align the mating marks of the clock spring.
<Mating Mark Alignment>
(1) Turn the clock spring clockwise fully. Then turn
it back approximately 3-3/4 turns
counterclockwise to align the mating marks.
(2) Turn the front wheels to the straight-ahead
position. Then install the clock spring to the
column switch.
CAUTION
Ensure that the steering wheel sensor’s mating
marks are properly aligned. If not, the steering
wheel sensor could be damaged.
2. Align the mating marks of the steering wheel
sensor as follows.
<Mating Mark Alignment>
(1) Turn the steering wheel sensor to the arrow
direction shown to align the mating marks.
(2) Align the mating marks on the clock spring and
the steering wheel sensor, and install the
steering wheel sensor to the column switch
assembly.
(3) Connect the steering wheel sensor connector.
AC303009
Mating marks
AE
AC308437AD
Steering wheel sensor
Mating mark
23B-1
GROUP 23B
AUTOMATIC
TRANSMISSION
OVERHAUL
CONTENTS
GENERAL INFORMATION . . . . . . . .
GENERAL SPECIFICATIONS . . . . . .
SERVICE SPECIFICATIONS. . . . . . .
SNAP RING, SPACER, THRUST WASHER,
THRUST RACE AND PRESSURE PLATE FOR
ADJUSTMENT . . . . . . . . . . . . . . . . . .
TORQUE SPECIFICATIONS . . . . . . .
SEALANTS . . . . . . . . . . . . . . . . . . . .
SPECIAL TOOLS. . . . . . . . . . . . . . . .
TRANSMISSION . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY. . . . .
OIL PUMP . . . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY. . . . .
UNDERDRIVE CLUTCH AND INPUT SHAFT
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY. . . . .
REVERSE AND OVERDRIVE CLUTCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
PLANETARY CARRIER ASSEMBLY
DISASSEMBLY AND REASSEMBLY . . . . .
LOW-REVERSE BRAKE . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
SECOND BRAKE . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
OUTPUT SHAFT. . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
DIFFERENTIAL. . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
VALVE BODY . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
DRIVE SHAFT OIL SEAL . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
GENERAL INFORMATION
AUTOMATIC TRANSMISSION OVERHAUL
23B-2
GENERAL INFORMATION
M1233000100470
AUTOMATIC TRANSMISSION MODELS
SECTIONAL VIEW
Transmission model
Combined engine
Vehicle model
F4A4B-2-N4Z
4G69-S4-MIVEC
NA4W
AK301433
GENERAL INFORMATION
AUTOMATIC TRANSMISSION OVERHAUL
23B-3
HYDRAULIC CIRCUIT
AK202328
1
2
3
4
5
6
7
8
9
10
14
11
12
13
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
AD
1.
Reverse clutch
2.
Low-reverse brake
3.
Second brake
4.
Underdrive clutch
5.
Overdrive clutch
6.
Low-reverse accumulator
7.
Second accumulator
8.
Underdrive accumulator
9.
Overdrive accumulator
10. Damper clutch
11. Fail-safe valve A
12. Fail-safe valve B
13. Damper clutch control valve
14. Cooler
15. Switch valve
16. Low-reverse pressure control valve
17. Second pressure control valve
18. Underdrive pressure control valve
19. Overdrive pressure control valve
20. Damper clutch control solenoid valve
21. Low-reverse solenoid valve
22. Second solenoid valve
23. Underdrive solenoid valve
24. Overdrive solenoid valve
25. Torque converter pressure control valve
26. Regulator valve
27. Manual valve
28. Oil filter
29. Oil pan
30. Oil pump
31. Relief valve
32. Oil strainer
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст