Mitsubishi Grandis. Manual — part 823
WINDSHIELD WIPER AND WASHER
EXTERIOR
51-27
NOTE: For removal and installation of the wiper and
washer switch, refer to GROUP 54A, Column switch
.
Removal service points
<<A>> Washer motor removal
Insert a (
−) screwdriver wrapped with protective tape
between the washer tank and the lower outer side of
the washer motor. Pry out the washer motor.
Washer tank removal steps
•
Front bumper assembly (Refer to
5. Washer tank assembly
<<A>>
6. Washer motor
7. Washer tank
8. Cap
9. Washer tank filler hose
Washer motor removal steps
10. Splash shield (RH)
6. Washer motor
AC302794AB
Washer motor
Washer tank
Flat-tipped screwdriver
REAR WIPER AND WASHER
EXTERIOR
51-28
INSPECTION
M1511019100501
WINDSHIELD WASHER FLUID EJECTION
CHECK
Move the nozzle to adjust the position so that the
spray is in the area shown in the illustration.
REAR WIPER AND WASHER
TROUBLESHOOTING
M1511020000188
The rear wiper and washer are controlled by the
Smart Wiring System (SWS). For troubleshooting,
refer to GROUP 54B, Troubleshooting
GROUP 54C, Troubleshooting
AC302128
260
27
65
174
70
260
514
352
27
65
174
70
AB
223
137
223
137
65
65
174
174
70
70
27
27
Windshield washer nozzle
<Left>
<Right>
Ceramic line terminal
Unit: mm
Windshield
washer
nozzle
perpendicular
Windshield
washer
nozzle
perpendicular
REAR WIPER AND WASHER
EXTERIOR
51-29
ON-VEHICLE SERVICE
Operation check of reverse gear-linked
operation of the rear wiper
M1511022600023
1. When the selector lever is moved to the "R"
position with the rear wiper switch at the "INT"
position, the wiper should operate twice or three
times at low speed after approximately one
second.
2. If not, carry out the troubleshooting. (Refer to
GROUP 54B
− Troubleshooting
GROUP 54C
− Troubleshooting
WASHER MOTOR INSPECTION (REAR
WASHER)
M1511019100686
1. Check the washer fluid level, and refill if
necessary.
2. Remove the splash shield.
3. Disconnect the washer motor connector.
4. Disconnect the rear washer hose as shown.
5. Connect the battery to the washer motor
connector as shown. Check that the washer motor
delivers washer strongly.
AC303909
AB
Rear washer hose
Washer motor
REAR WIPER AND WASHER
EXTERIOR
51-30
REAR WIPER AND WASHER
REMOVAL AND INSTALLATION
M1511008500163
NOTE: For removal and installation of the wiper and
washer switch, refer to GROUP 54A, Column switch
AC312141
4
1
9
8
7
6
5
3
AB
2
7.4 ± 1.4 N·m
7.4 ± 1.4 N·m
9.8 ± 2.0 N·m
7.4 ± 1.4 N·m
Washer tank assembly removal
•
Washer tank (Refer to
.)
•
Rear washer nozzle removal steps
•
Tailgate spoiler (Refer to
•
High-mounted stop lamp assembly
(Refer to GROUP 54A, High-mounted
stop lamp
1. Rear washer nozzle assembly
Rear wiper blade removal steps
2. Rear wiper blade assembly
>>A<<
3. Rear wiper blade
Rear wiper motor removal steps
>>B<<
4. Rear wiper arm blade assembly
•
Tailgate trim (Refer to GROUP 52A,
Tailgate trim
5. Cover
6. Nut
7. Washer packing
8. Rear wiper motor assembly
Rear washer hose removal steps
•
Cowl side trim, front scuff plate, rear
scuff plate, quarter trim (Refer to
GROUP 52A, Interior trim
•
Tailgate trim (Refer to GROUP 52A,
Tailgate trim
.)
>>C<<
9. Rear washer hose
Rear wiper motor removal steps
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст